Shark PowerDetect™ Quick Start Guide
Settings
Touchscreen Selector: To switch between modes, gently tap the desired mode icon.
- Detect Mode: Select Detect mode to activate Smart Detect Technology. In this mode, the vacuum will detect floor type, dirt, and edges, and will automatically adjust suction to maximize cleaning performance.
- Manual Surface Modes: Select one of the manual surface modes (Hard Floor, Carpet, or Thick Carpet) to clean specific surfaces without Smart Detect Technology.
Smart Detect Technology Suite
FloorDetect™
Identifies surface type and adjusts brushroll speed and suction for optimized cleaning.
DirtDetect
Identifies dirty areas and automatically boosts suction power to pull in hidden dirt.
EdgeDetect
Focuses and maximizes suction along corners and edges to target stubborn dirt.
Detect Indicators
DirtDetect Indicator: Shows when DirtDetect is active.
Cleaning Indicators:
- Cleaning (White)
- Cleaning Boost (Purple)
EdgeDetect Indicators:
- [left arrow] Left Edge
- [right arrow] Right Edge
Sensor Cleaning
Clean the sensors when the DIRTDETECT icon turns red. If the sensors are partially obstructed, Detect mode will not function as expected. If the icon is still red after cleaning, refer to Detect Sensor Maintenance in the Owner's Guide.
Cleaning the Detect Sensors
Sensors Require Cleaning (Red) [red sensor alert icon]
- Turn off power and remove the floor nozzle.
- Locate the DirtDetect sensor in the nozzle (Fig. 1), the FloorDetect sensor on the bottom of the nozzle (Fig. 2), and the EdgeDetect sensors on both sides of the nozzle (Fig. 3).
- Gently wipe the sensors with a microfiber cloth and remove all hair and debris.
- Reattach the floor nozzle to the rest of the unit and turn on power. Verify the unit is functioning normally.
