Everbilt Submersible Waterfall/Utility Pump

Installation and Operation Steps

1. Select the correct adapter attachment for connecting the discharge line, dependent on the pump application.

2. Install the pump on a firm, level base. Avoid pumping mud, rock, or other debris.

   Diagram Description: The pump is shown placed on a flat base. Dimensions indicate a minimum water depth of 2-9/16 inches is needed for priming and the pump can remove water down to 2 inches.

3. The pump will need a minimum of 2-9/16" of water to prime. Once primed, the pump can remove water down to 2".

4. Plug the pump into a 115V GFCI Power Outlet.

   Diagram Description: The pump is shown plugged into a wall outlet labeled 'GFCI Outlet'.

5. To avoid airlock, the pump must be sufficiently submerged before pumping. If the pump is not pumping, tilt the pump to release the air bubbles from the bottom, then return to the vertical position. Unplug the pump from its power source when finished pumping; do not let the pump run dry.

   Diagram Description: The pump is shown tilted to release air bubbles from its base.