STF Allure 8"x2 Portable Wireless Speaker with RGB LED Light
Model: ST-S12544
Welcome to Your New Allure Speaker
Congratulations on your new STF® Allure 8"x2 wireless speaker! This manual will guide you through all its features to enhance your audio experience. Get ready to bring your soundtrack anywhere with powerful sound and practical functions.
Important: Please read this manual carefully before use to familiarize yourself with all the speaker's features. Ensure the speaker is fully charged before its first use for optimal performance.
FCC Compliance Note: This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Package Contents
- 01. Wireless Speaker: 1 piece
- 02. Charging Cable: 1 piece
- 03. User Guide: 1 piece
Speaker Diagram
Refer to the diagram for component identification:
- 1. 6.3 MM MICROPHONE INPUT
- 2. 6.3 MM MICROPHONE INPUT
- 3. 3.5 MM AUXILIARY AUDIO INPUT
- 4. USB MEMORY INPUT
- 5. MICRO SD MEMORY INPUT
- 6. 5V USB CHARGING OUTPUT
- 7. POWER INPUT
- 8. PREVIOUS SONG
- 9. PLAY / PAUSE SONG
- 10. NEXT SONG
- 11. MASTER VOLUME KNOB
- 12. FUNCTION CHANGE
- 13. POWER ON / OFF BUTTON
- 14. EQUALIZER / TWS CONNECTION
- 15. MICROPHONE VOLUME KNOB
Specifications
- Wireless Connection: 5.3
- Wireless Range: 10 m (33 ft)
- TWS Wireless Connection: Yes
- Tweeter Diameter: 3" (7.62 cm) x 2
- Woofer Diameter: 8" (20.32 cm) x 2
- Impedance: 4 ohm
- Output Power: 60 W
- Sound Pressure: 100 dBSPL
- Frequency Range: 75Hz - 18 kHz
- Battery Capacity: 5400 mAh
- Playback Time: 3 hours
- Charging Time: 3 hours
- Power Supply: 5 Vcc 1 A
- Charging Input: Type-C
- Memory Input: USB, Micro SD (up to 64 GB)
- FM Radio: Yes
- Auxiliary Audio Input: 3.5 mm x 1
- Microphone Input: 6.3 mm x 1
- Lighting Type: RGB LED
- Additional Functions: Power bank function
Instructions for Use
Powering On and Off
- To turn the speaker on, press and hold the Power On/Off button for 3 seconds. You will hear an indicator sound.
- To turn the speaker off, press and hold the Power On/Off button for 3 seconds.
Wireless Connection
- Turn on the speaker by pressing the Power On/Off button for 4 seconds. The wireless connection mode will activate automatically.
- Note: Maintain a distance of no more than 60 cm (approx. 2 ft) during connection and avoid obstacles that may interfere with the signal.
- On your device (phone, tablet, laptop, etc.), go to wireless settings and select the speaker's name to pair: STFALLURE 8x2.
- Note: If your device prompts for a password, enter the default: 0000.
- Once paired, the speaker will remain connected unless manually disconnected or the connected device is restarted.
Audio Playback
- To skip to the next song, press the Next Song button once.
- To go back to the previous song, press the Previous Song button once.
- To play or pause a song, press the Play/Pause Song button once.
- To adjust the volume, turn the Master Volume Knob.
- Note: If you cannot establish a connection, repeat the previous steps.
True Wireless Stereo (TWS) Function
- Turn on both speakers by pressing the Power On/Off button for 3 seconds. The wireless connection mode will activate automatically.
- On one of the speakers, press and hold the EQ/TWS button for 4 seconds.
- You will hear a sound indicating that both speakers have successfully connected.
- Note: It is important not to have any wireless device (phone, tablet, laptop, etc.) connected prior to establishing the True Wireless connection.
- To adjust the volume, turn the Master Volume Knob.
3.5 mm Auxiliary Audio Input
- Turn on the speaker. The wireless connection mode will activate automatically. Press the Function Change button until you hear the auxiliary audio input function.
- Insert the 3.5 mm audio cable into the corresponding connector.
- To adjust the volume, turn the Master Volume Knob.
- Note: In AUX mode, you cannot change the previous or next song; control is only possible from the connected device.
USB Memory / Micro SD Card Function
- Turn on the speaker. The wireless connection mode will activate automatically. Press the Function Change button until you hear the USB/Micro SD memory input function. Insert a USB drive or Micro SD card into the corresponding port, and music in MP3 format will play automatically.
- To skip to the next song, press the Next Song button once.
- To go back to the previous song, press the Previous Song button once.
- To play or pause a song, press the Play/Pause Song button once.
- To adjust the volume, turn the Master Volume Knob.
- Note: Audio files must be in MP3 or WMA format. Other formats will not be played.
- Note: The maximum supported capacity for memory cards is 64GB.
FM Radio Function
- Turn on the speaker. The wireless connection mode will activate automatically. Press the Function Change button until you hear the FM radio function.
- To scan FM radio stations, press and hold the Play/Pause Song button for 3 seconds.
- To go to the next FM station, press the Next Song button once.
- To go to the previous FM station, press the Previous Song button once.
- To adjust the volume, turn the Master Volume Knob.
Equalizer
In any function, briefly press the EQ/TWS button to cycle through the 6 equalization presets.
LED Lighting
In any function, press the Power On/Off button to cycle through the different LED lighting modes.
Microphone Function
In any function, connect a microphone to the 6.3 mm microphone inputs. Adjust microphone volume using the Microphone Volume Knob.
Important Information and Precautions
- Always read the user manual of the device you are connecting to the speaker.
- Do not expose the speaker to high temperatures or direct flames.
- Keep the speaker away from dirt, dust, and corrosive substances.
- This product may not guarantee correct operation with all mobile phones and devices using wireless connections from other brands.
- The wireless technology of this product has an approximate transmission range of 10 meters (33 ft). However, obstacles such as people, objects, walls, trees, and other devices can interfere with the actual transmission range.
- Due to the nature of wireless technology, there may be a slight delay between the sound transmitted by the device and the sound from the speaker.
- Do not disassemble or attempt to repair the speaker yourself. Contact authorized technical support if damaged.
- Avoid using the speaker in humid environments that could cause damage.
Warranty
Stuffactory, S.A. de C.V. guarantees the purchased product for a term of 5 years on all its parts against any manufacturing defect from the moment of purchase.
You can consult the full manual on our website www.stf.tech or by scanning the QR code.
To Activate Warranty:
- Contact us via phone at 33 8995 2505 or via email at soporte@stuffactory.mx.
- The warranty must be duly sealed and signed by the establishment where the product was purchased.
- Present the purchase receipt clearly showing the date of purchase. The receipt must be in good condition, without alterations or erasures.
Warranty Void Conditions:
- If the product has been used under conditions other than normal (e.g., water damage, burns, misuse).
- If the product has not been operated according to the accompanying user instructions.
- If the product has been opened, altered, or repaired by unauthorized personnel.
Support and Customer Service
If your product has a factory defect covered by the warranty, please contact us:
- National toll-free number: 33 8995 2505
- WhatsApp: 33 2181 9661
- Email: soporte@stuffactory.mx