Ruvati RVA5102 Bathroom Sink Popup Drain Installation Guide
This guide provides instructions for installing the Ruvati RVA5102 popup drain with a vessel sink that has no overflow.
Attention Installer
- Carefully read all instructions before installation. Inspect all parts against the parts list.
- For missing or damaged parts, contact Ruvati Support at 1-855-478-8284 or visit www.ruvati.com.
- Seek assistance from a professional plumber if you encounter difficulties or are uncertain about any installation step.
Installation Guide
Included in Box
The Ruvati RVA5102 popup drain kit includes the following components:
- Pop Up Drain Top (approx. 2-5/8" diameter)
- Thin Soft Rubber Washer
- Rubber Ring
- Rubber Ring
- White Plastic component
- Lock Nut
- Paper Washer
- Tail Pipe (approx. 5" length, 1-1/4" diameter)
Installation Steps
- Position Sink: Determine the sink's placement on the countertop. Mark and create a 1-3/4" hole in the countertop, aligned with the sink's drain opening.
- Mount Sink: Apply silicone adhesive around the sink's bottom edge. Place the sink onto the countertop, aligning it with the pre-drilled hole.
- Insert Drain Body: From the top of the sink, insert the Drain Body and one Rubber Ring through the sink's drain opening.
- Secure from Below: From under the countertop, place the second Rubber Ring onto the base of the drain. Push it upwards until it sits flush with the countertop surface.
- Attach White Plastic: Place the White Plastic component onto the base of the Drain Body, pushing it up until it is flush with the Rubber Ring.
- Tighten Lock Nut: Screw the Lock Nut upwards until it makes contact with the White Plastic component.
- Connect Tail Pipe: Place the Paper Washer onto the tailpipe. Screw the Tail Pipe into the Drain Body by hand. Ensure it is securely tightened, but avoid overtightening.
Diagram Description: The installation process involves assembling the drain components through the sink and countertop. From the top, the drain top is inserted. From the bottom, rubber rings, a white plastic part, and a lock nut are secured to create a seal against the countertop. The tailpipe then connects to the drain body for water drainage.
Product Registration & Support
To register your product, please visit: www.ruvati.com/register-product
Ruvati USA
Address: 2705 Meister Pl, Round Rock, TX 78664
USA Phone: 1-855-478-8284
Email: support@ruvati.com
