INSTALLING A POPUP DRAIN
Ruvati Installation Guide
Bathroom Sink Popup Drain
Model: RVA5103
Important Notes
These instructions are for installing the drain with a sink that has no overflow.
Use either Plumber's Putty or a Foam Washer. DO NOT USE BOTH.
Attention Installer
- Read all instructions carefully before installation. Inspect the item and make sure you have all the parts shown in the parts list.
- If any part is missing or damaged, please contact Ruvati Support at 1-855-478-8284 or visit www.ruvati.com.
- Consult with a professional plumber if you encounter difficulties or are unsure about any step in the process.
Product Registration
Register your product at: www.ruvati.com/register-product
Contact Information
RUVATI
Address: 2705 Meister Pl, Round Rock, TX 78664
USA Phone: 1.855.478.8284
Email: support@ruvati.com
Website: www.ruvati.com
Included in Box
The following parts are included:
| Part | Description/Dimensions |
|---|---|
| Pop Up Drain Top | Diameter: 1-3/8 inches |
| Drain Body | Height: 2-1/2 inches; Diameter: 1-1/2 inches |
| Foam Washer | Thickness: 1/8 inch |
| Rubber Ring | (Shape and function described in installation steps) |
| Tail Pipe | Total Length: 5-7/8 inches; Diameter: 1-1/4 inches |
Note: Dimensions are approximate as shown in the included diagram.
Installation Guide
For All Sink Types
- Insert the Drain Body and Foam Washer, or apply a thin bead of Plumber's Putty around the drain opening from the top of the sink.
- From under the countertop, place the Rubber Ring on the base of the drain. Then push it all the way up until it is flush with the counter.
- Now, screw the Tail Pipe all the way up until it meets the Rubber Ring and is tight. Be sure not to overtighten it.
For Vessel Sinks
- Determine the position of the sink on your countertop, then drill a hole that is appropriately sized for your specific sink type.
- Apply a bead of silicone adhesive around the bottom edge of the sink (or mounting surface), then place the sink on the countertop and align it with the drain hole.
