Operation Instructions
On/Off: Press and release the silver button on the side of the light to turn it on and off.
A visual representation shows a finger pressing the side button of the flashlight.
Cycle Modes: Press the button quickly to cycle through modes (Flashlight/Area Light/Red Strobe). If the light remains in a single mode for longer than 3-5 seconds, the next press of the button will turn the light off. The light automatically resets to Flashlight High mode when turned off.
Adjust Brightness: Brightness in both Flashlight and Area Light modes can be adjusted by pushing and holding the button. The amount of light emitted will decrease/increase with a quick pause in the beam to indicate the highest/lowest light output.
Features
- Constructed with aircraft-grade aluminum
- LPE optics
- Broad Beam surface LED
- Variable brightness
- Strong magnetic base
- Ergonomic side button
- IPX4 waterproof rating
- Batteries included (4 AAA)
Battery Replacement
The LP485 uses 4 AAA batteries.
To replace the batteries, turn the tail cap counterclockwise to remove it. Tip the light downward to slide the batteries out of the tubes. Insert new batteries into the light according to the (+/-) symbols shown above the tubes. The batteries will stick out of the opening slightly. For best results, LuxPro recommends using brand new alkaline batteries that are the same voltage and brand. Re-attach the tail cap by pressing down and turning it clockwise until tight.
An illustration shows the flashlight tail cap, four AAA batteries, and a battery compartment.
If the flashlight will not be used for an extended period, LuxPro suggests removing the batteries and storing them in a dry, protected place.
Specifications (ANSI/PLATO FL1 STANDARD)
| MODES | LUMENS [light-symbol] | RUN TIME [clock-symbol] | BEAM DISTANCE [arrow-symbol] |
|---|---|---|---|
| Flashlight | |||
| High | 537 lm | 1h 30m | 295m |
| Low | 100 lm | 6h 15m | 130m |
| Area Light | |||
| High | 416 lm | 3h | 31m |
| Low | 63 lm | 13h | 12m |
