Vollrath Installation Instructions

These instructions cover the installation of the one piece Cafeteria Breath Guard and the three piece Cafeteria Breath Guard.

One Piece Breath Guard Installation

Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:

Note: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
2. Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
3. Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
4. Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.

Figure 1: One Piece Breath Guard Installation depicts the assembly of uprights (A) to studs (B) using cap nuts (C), the attachment of the support tube (D) between uprights (A), the installation of the one piece breath guard (E) with screws (F) and cap nuts (C), and the securing of the side breath protector (G) to the support tube (D) with cap nuts (C).

Three Piece Breath Guard Installation

Some units are shipped with a breath guard not installed. To install the breath guard follow these steps:

Note: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
2. Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
3. Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
4. Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
5. Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
6. Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.

Figure 2: Three Piece Breath Guard Installation illustrates the assembly of uprights (A) to studs (B) with cap nuts (C), the connection of the support tube (D) between uprights (A), the attachment of side breath guards (E) using screws (F) and cap nuts (C), the securing of the side shield (G) to the support tube (D) with cap nuts (C), the installation of the support bar and stud assembly (H) to the side breath guards (E), and the final attachment of the top breath guard (I) to assembly (H) with cap nuts (C).