Firmware Update for Pioneer VSX-LX805 AV Receiver
Current Version: R121-0607-1132-0133
Update Date: 07-01-2025
Introduction
This firmware update provides the best possible performance for your Pioneer VSX-LX805 AV Receiver. The update can be installed via USB or Network.
Update Details
07/01/2025 Update
This update includes previous updates and addresses the following:
- Fixes an issue where the DLBC (Dirac Live Base Control) / DLBM (Dirac Live Base Management) crossover was applied incorrectly. After applying the update, please re-export/transfer the filter (target EQ) to each slot.
- Minor bug fixes and stability improvements.
- Adds setup microphone switching procedure. For details, refer to: Switching-the-Setup-Microphone_P-_Rev1.pdf
03/12/2025 Update
- Stability is improved and minor bugs are fixed.
11/18/2024 Update
- Introduces Google Cast 2.0. The method for network connection will be changed. For details, please refer to: https://assets.pioneerhomeusa.com/product-manuals/SN29404182_CAST2.0_Pio_241025.pdf
- Adds support for Tidal MAX.
- Improves the Dirac Live measurement on the Pioneer Application.
- Minor bug fixes and stability improvements.
04/23/2024 Update
- Minor bug fixes and stability improvements.
12/04/2023 Update
- Roon Ready update: Updated from "Roon Tested" to "Roon Ready".
- Added "Pre amp mode".
09/05/2023 Update
- Adds Auro 3D function.
- Adds SBTM (Source Based Tone Mapping) of HDMI 2.1a.
- Enables Dolby Atmos Music playback capability of Amazon Music HD.
- Raises the upper limit of the Dirac delay time from 20 msec to 50 msec.
- Fixes the issue of displaying messages related to OSD signals when connecting the Optoma projector.
- Fixes the issue where enabling Bluetooth transmission would prevent HLG display.
- Minor bug fixes and stability improvements.
Firmware Update Instructions
Update the firmware via network or USB connection.
Updating the firmware via network: You can update the firmware by connecting the unit to a network.
Updating the firmware via USB connection: You need a 128 MB or larger capacity USB storage for updating.
For details, see "Firmware Update" of the Instruction Manual.