Marantz CD60 CD Player
QUICK START GUIDE
This guide provides instructions for setting up and operating your Marantz CD60 CD Player.
Before you begin
What's in the box
- Quick start guide
- Safety Instructions
- Cautions on Using Batteries
- CD Player
- Power cord
- Remote control (RC005PMCD)
- 2× R03/AAA batteries
- Audio cable
- Remote connector cable
Required for setup
- Amplifier
- Speakers
- Speaker cables
Setup
1 Connect the amplifier
Connect the audio output from the CD60 to the audio input of your amplifier using the provided audio cable. The CD60 has RCA audio outputs (Left and Right) and the amplifier has corresponding audio inputs.
2 Connect to power
Connect the power cord to the AC IN port on the back of the CD60 and then plug the other end into a wall outlet.
3 Install batteries in the remote control
Open the battery compartment on the back of the remote control. Insert two R03/AAA batteries, observing the correct polarity. Close the battery compartment.
4 Begin CD playback
- Press the CD button on the remote control.
- Press the △ button (open/close tray) to open the disc tray.
- Place a CD in the disc tray with the label side facing up.
- Press the ☐ button (play/pause) to start playback.
Contact Marantz
For any questions or support, contact Marantz via the helpline at 00800-43674357. You can also find more information on the support section of the Marantz website: www.marantz.com.
Owner's manual
For detailed information on other functions and operation procedures, refer to the online manual at: manuals.marantz.com/CD60/EU/EN/.