HINKLEY Transformer Mounting Instructions

Installation Steps

1. First plug photocell jumper (3) in (if needed).
2. Next knockout conduit knockout in order to create an opening for dimmer box (1).
3. Secure dimmer box (1) to transformer using lock ring (2). Wires from dimmer box should run through the conduit knockout.
4. Connect key connectors form dimmer box (5) and daughter board (6) together.
5. Connect the free wires from the dimmer box into the COM and 12V terminal block connectors (7, 8).
6. Connect light fixture wires to the positive and negative terminals at the end of the daughter board.

   Note: Fixture wire can be larger than 10 gauge and cannot be used on the daughter board. The board also features two positive and negative terminals to run multiple fixture lines. Wire zone 1 fixtures to Z1+ and Z1-, and wire Zone 2 fixtures to Z2+ and Z2-.

7. Use wall plug (4) to power on transformer.
8. Download the Hinkley app to control dimmer settings. Refer to page 2 for app instructions.