SKOGSNÄS METOD
Assembly Instructions
Important Safety Information
Before proceeding with installation, please read the safety information provided in the user manual. Follow all steps in the assembly instructions carefully.
[warning] Do not use an extension cable or a multi-plug when connecting to electricity.
[warning] Two people are required for handling and installation of this appliance.
[warning] Ensure proper ventilation clearances as indicated in the manual.
[info] Allow 4 hours after installation before connecting to power.
Tools and Parts Required
Tools:
- Screwdrivers (Phillips, flathead)
- Hammer
- Tape measure
- Safety glasses
- Ladder
Parts:
The following parts are included in the package:
- Part A: 4x
- Part B: 1x (used multiple times)
- Part C: 4x
- Part D: 2x
- Part E: 1x
- Part F: 2x
- Part G: 1x (used twice)
- Part H: 1x (used twice)
- Part I: 4x
- Part J: 1x
- Part K: 4x
- Part L: 8x
- Part M: 1x
- Part N: 1x
Assembly Steps
Step 1: Prepare the Unit and Cabinet
Verify all parts are present. Ensure the appliance and cabinet are ready for assembly. Note appliance dimensions: Height 1964 mm, width 564 mm, depth 550 mm. Required clearances include minimum 560 mm above and minimum 200 cm² ventilation.
Step 2: Attach Mounting Brackets to Appliance
Attach various mounting brackets (Parts I, K, D, E, B) to the appliance body and doors using screws, following the specific locations and orientations shown in the diagrams.
Step 3: Attach Mounting Brackets to Cabinet
Attach corresponding mounting brackets to the cabinet sides and top, using screws as indicated.
Step 4: Install Hinges
Install hinge components (Parts B, D, E, M) onto the appliance body and doors. Ensure correct orientation for door swing (up to 180 degrees).
Step 5: Mount Doors to Appliance
With assistance from another person, carefully lift and attach the doors to the appliance body using the installed hinges. Use a ladder for safe access when needed.
Step 6: Attach Door Handles and Covers
Attach door handles (Part H) and any decorative covers (Parts F, J) to the doors using the provided screws.
Step 7: Integrate Appliance into Cabinet
Two people are required to carefully insert the appliance into the cabinet. Ensure the appliance is centered and electrical cables are not pinched. Check for proper fit within cabinet height options (e.g., 200 cm, 220 cm, 240 cm).
Step 8: Secure Appliance to Cabinet
Secure the appliance to the cabinet using the attached brackets and screws.
Step 9: Adjust Door Alignment
Adjust the hinges to ensure the doors are level, aligned correctly, and have the proper gap between them and the cabinet. Aim for a minimum gap of 2mm, and fine-tune to 0-1mm for optimal closure.
Step 10: Final Checks
Verify all screws are tightened and the doors open and close smoothly. Ensure the appliance is stable and correctly positioned. Confirm all assembly steps are completed.
Step 11: Electrical Connection
[info] After completing the installation, wait 4 hours before connecting the appliance to the electrical outlet. Do not use extension cords or multi-plugs.
