Touratech 01-065-0292-0 BMW CAN-BUS Cable Installation Guide
Brand: Touratech
Date: January 2022
Manufacturer: Touratech GmbH, Germany
General Recommendations & Safety
Installation Recommendation: We recommend having accessory parts fitted by a specialist workshop.
Important Notes:
- Caution ⚠️
- Note ℹ️
- Warning ❗
- Liquid ?
- Torque ?
- Template ?
- 2 Persons ???
- Original Motorcycle Part ?️
Torque Specifications
| Bolt Size | Steel 8.8 (Nm) | Inox A2 (Nm) |
|---|---|---|
| M 4 | 2,7 | 0,8 |
| M 5 | 5,5 | 1,7 |
| M 6 | 9,7 | 3,0 |
| M 8 | 23,0 | 7,9 |
| M 10 | 47,0 | 14,0 |
| M 12 | 80,0 | 24,0 |
| M 14 | 130,0 | -,- |
| M 16 | 196,0 | 59,0 |
| M 18 | 270,0 | -,- |
| M 20 | 385,0 | 114,0 |
General Installation Advice:
- These instructions are based on current knowledge and are subject to technical modifications.
- Follow the assembly steps in the specified order.
- Touratech is not liable for incorrectly fitted parts or resulting damages.
- Observe national and EC/ECE road vehicle regulations. Have approved parts inspected and registered.
- Check and tighten all bolted connections after 50 km.
- Standard tightening torques are for strength class 8.8 bolts. Consult a specialist workshop for specific torques.
- Be aware that fitting accessories like panniers, crash bars, foot peg lowering kits, or engine guards may restrict the motorcycle's lean angle.
- When modifying fairings, handlebars, etc., ensure electrical wiring, brake lines, and cables are correctly rerouted and checked for clearance with full steering lock.
- Always disconnect the battery before working on the electrics.
- Consider applying protective film to areas prone to stone chips.
- Brake system and suspension work should only be performed by a specialist workshop.
- Maximum load for luggage racks: 5 kg (ZegaPro TC: 10 kg).
- When using original or aftermarket accessories, check for clearance, fitment, and potential collisions.
- Lubricate stainless steel bolts before assembly.
- PDF fitting instructions are available for download on the Touratech webshop.
Product Specific Installation: 01-065-0292-0 BMW CAN-BUS Cable
This section details the installation of the 01-065-0292-0 BMW CAN-BUS Cable.
Wiring Diagram Description
The diagram illustrates the connection of a GPS Navigation unit to the motorcycle's CAN-BUS system using the provided cable.
- The cable splits into two.
- One branch, colored Red (Rot), connects to the positive (+) terminal.
- The other branch, colored Blue (Blau), connects to the CAN-BUS system.
- Both cable sections are rated for 0.5 to 1.0 mm² wire gauge.
- Connections are made using heat shrink connectors (labeled '1').
- Ensure the connector is heated to approximately 125°C to create a secure connection.
- Approximately 5 mm of wire should be exposed on each side of the connector before crimping.
- The diagram shows the Blue wire connecting to the motorcycle's CAN-BUS port, indicated by a motorcycle symbol.
