Super Mario Rumble RC Racer

Product Identification

Model Numbers: 41822TXNT (Controller), 41822RXNT (Racer)

Brand: Jakks Pacific

Associated Brands: Nintendo

Package Contents

Ensure all parts are present before beginning:

• Super Mario Rumble RC Racer
• Controller
• Instruction Manual

Battery Installation

Important: Adult installation is required.

Controller Battery Installation (Requires 2 x 1.5V AA/LR6 Batteries - Not Included)

1. Locate and open the battery cover on the controller using a Phillips head screwdriver (not included).
2. Install 2 x 1.5V AA (LR6) alkaline batteries, observing the correct polarity (+ and -).
3. Replace the battery cover and tighten the screw.

Racer Battery Installation (Requires 6 x 1.5V AA/LR6 Batteries - Not Included)

1. Ensure the Racer is in the OFF position.
2. Locate and remove the battery cover from the underside of the Racer using a Phillips head screwdriver (not included).
3. Install 6 x 1.5V AA (LR6) alkaline batteries, observing the correct polarity (+ and -).
4. Replace the battery cover and tighten the screws.

Note: Batteries included are for 'Try Me' purposes only. Replace with fresh batteries for optimal performance.

Operation

Powering On and Syncing

1. Turn the controller power switch to the 'ON' position.
2. Turn the Racer's power switch to the 'ON' position.
3. The power light on the controller will flash to sync with the Racer. Once the light stops flashing and remains solid, the sync is complete.

Driving Controls

• Left Stick: Controls forward/reverse movement.
• Right Stick: Controls left/right steering.
• Front Wheel Knob: Fine-tune the front wheel steering angle by turning the knob left or right.

Special Features

• Mario Head and Arm Rotation: Shift and hold the right stick in either direction to rotate Mario's head and arms.
• Exhaust Pipe Rumbling: Shift the left stick forward/reverse to activate the rumbling effect.

Troubleshooting

Important Safety Information

• Age Recommendation: Not recommended for children under 4 years of age.
• Operation: Read instructions before operating. Avoid hitting people, pets, or furnishings. Never operate in the street.
• Precautions: Keep hair, hands, and clothing away from the vehicle when the power switch is ON. Do not pick up a moving vehicle.
• Storage: Remove batteries when the vehicle is to be stored for an extended period. Do not store in direct sunlight.
• Surface Compatibility: The vehicle works best on smooth, flat, clean, dry surfaces free of dirt and dust. Not intended for use on carpet.

Battery Safety Information

• Warning: Battery acid leakage can cause personal injury and damage. If leakage occurs, wash affected skin thoroughly and keep acid away from eyes, ears, nose, and mouth. Wash contaminated clothing immediately.
• Disposal: Dispose of batteries according to local laws and recycling regulations.
• General Precautions: Never mix old and new batteries or different battery brands. Never mix alkaline, standard (carbon-zinc), or rechargeable batteries. Never dispose of batteries in fire. Always remove batteries when exhausted or unused for a long time. Always have an adult install batteries with correct polarity. Only use specified batteries. Do not short-circuit terminals. Do not recharge non-rechargeable batteries. Charge rechargeable batteries only under adult supervision.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. This device complies with Industry Canada license-exempt RSS standard(s).