UniFi Access G3 Reader

Overview

Compact, third-generation NFC card reader and request-to-exit device that supports hand-wave door unlocking and Touch Pass.

Mechanical

• Dimensions: 93 x 40 x 36.5 mm (3.7 x 1.6 x 1.4")
• Weight: 82 g (2.9 oz)
• Enclosure material: Polycarbonate, glass
• Mounting: In wall, gang box
• Weatherproofing: IP55

Hardware

• Networking interface: (1) 10/100 MbE RJ45 port
• Connectivity: BLE 4.1, NFC
• Power method: PoE
• Supported voltage range: 48V DC
• Max. power consumption: 5W
• ESD/EMP protection: Air: ±15kV, contact: ±8kV
• Sensors: Proximity sensor
• Speaker: (1) 8 ohm, 0.7W
• LEDS:
  • Steady white: Pending adoption
  • Steady blue: Adopted
  • Alternating white/blue: Firmware updating
  • Strobing red: Emergency lockdown
  • Steady green: Emergency evacuation
  • (2) Rapid flashing blue: NFC credential authenticated
  • (2) Rapid flashing red: NFC credential authentication failed
  • Breathing blue: Ready to register NFC cards
• Button: (1) Factory-reset
• NFC frequency: 13.56 MHz
• NFC read range: < 30 mm
• NFC standards: ISO 14443A, 14443B, 15693
• NFC technology: NFC Tag 1,2,3,4,5, MIFARE Classic, MIFARE Plus, MIFARE Ultralight, MIFARE DESFire

Environmental and Software

• Operating environment: Outdoor use
• Operating temperature: -30 to 45° C (-22 to 113° F)
• Operating humidity: 5 to 90% noncondensing
• Software information: The software version of a product can be checked at https://unifi.ui.com
• Certifications: CE, FCC, IC
• Document number, and issue date and/or revision level: UA-G3-W/UA-G3-B, V01

E-label and Warnings

E-label and warning statements can be found in the device/controller GUI under Device > Overview > E-label info.