HOMCOM 700-157V80 Electric Recliner Chair with Ottoman

General Information

This product is intended for domestic use only.

Instructions for Use

• Place the chair stably on a flat floor.
• Keep away from open flames or heat sources.
• Avoid overloading the chair.

Precautions

Before Assembly

• Prepare a clean and dry mounting area.
• Verify that the product is not damaged.
• Check that none of the pieces are missing.

During Assembly

Beware of crushing and cutting hazards during assembly. Please handle with care.

General

The manufacturer declines all responsibility in case of damages due to improper installation or weather conditions.

If the seating is fitted with powered seat height adjustments, only trained personnel may replace or repair those components.

Maintenance

• Clean the chair with a soft fabric.
• Check the seating regularly.

Storage Conditions

The fabric should be stored completely dry, in a clean and dry place to avoid the risks of mold.

Assembly Parts

Parts

• Part A (x1)
• Part B (x1)
• Part C (x1)
• Part D (x1)
• Part K (x1)
• Part L (x1)

Hardware

• Hardware E (x1)
• Hardware F (x2)
• Hardware G (x4) - M8*35
• Hardware H (x4) - M6*40
• Hardware I (x4)
• Hardware J (x1) - Allen Key

Note: Do not tighten bolts fully until all parts are connected.

Assembly Steps

Step 01: Attach Part F to Part A (backrest). The diagram shows Part F being secured to the underside of the backrest with screws.

Step 02: Connect Part E to the base structure. The diagram shows a component labeled 'E' being attached to the circular base with screws.

Step 03: Attach Part C and Part B to the base structure using screws H and the Allen key J. The diagram illustrates connecting curved support pieces (C, B) to the main frame.

Step 04: Attach Part D to the base structure using screws G and washers I. The diagram shows a circular component (D) being secured to the base with bolts and washers.

Step 05: Final assembly of the chair and ottoman, connecting the power cable (L) and controller (K) to the unit. The diagram shows the completed chair with the electrical components attached.

Controller Functions

Graphic Presentation of Controller

The controller features buttons for various functions, typically arranged around a central silhouette of a person indicating massage zones:

• POWER: Turn on/off
• INTENSITY: High/Low selection
• MODE: Working mode selection
• BACK: Back massage function
• LUMBAR: Lumbar massage function
• THIGH: Thigh massage function
• LEG: Leg massage function

Operating Instructions

1. Insert the power into the DC socket.
2. Press the POWER key to start the unit.
3. Press the MODE key to select different working modes (PULSE, PRESS, WAVE, AUTO, NORMAL).
4. Press the INTENSITY key to switch the intensity of vibration.
5. Press the BACK, LUMBAR, THIGH, and LEG keys to massage different parts of the body.

Technical Specifications