VEVOR

Overview

VEVOR is committed to providing tools at competitive prices. The terms "Save Half" and "Half Price" represent an estimate of potential savings compared to major brands and do not necessarily apply to all product categories. Please verify savings carefully when placing an order.

Need Help? Contact Us!

Have product questions? Need technical support? Please feel free to contact us: ? CustomerService@vevor.com

This is the original instruction. Please read all manual instructions carefully before operating. VEVOR reserves the right to interpret its user manual. The appearance of the product is subject to the item received. We will not provide further notice for technology or software updates on our product.

Specifications

Features Include

• ✔️ (3) color LED indicator lights
• ✔️ Weather resistant
• ✔️ Limited lifetime warranty
• ✔️ Pull handle on plug
• ✔️ Portable, just plug it in

Installation Steps

Step 1

Plug Surge Protective Device into AC power. DO NOT plug in your RV at this time. Verify GREEN surge indicator LED(s) is on.

Step 2

Verify which LED's come on.

The Correct Wiring condition occurs when both the GREEN and BLUE LED'S are on. If this does not occur, you may be experiencing one of the other three (3) Wiring Conditions:

Wiring Conditions & LED Indicators:

• A: Correct Wiring: GREEN LED ON, BLUE LED ON, RED LED OFF.
• B: Reverse Polarity: GREEN LED ON, BLUE LED OFF, RED LED ON.
• C: Open Neutral: GREEN LED ON, BLUE LED ON, RED LED ON.
• D: Open Ground: GREEN LED ON, BLUE LED OFF, RED LED OFF.

Note: The Green light turning off indicates a surge occurrence.

Step 3

Plug in your RV power to the Smart Surge Protector. Refer to STEP 2 above for surge protection wiring conditions.

Your Surge Protective Device will continue to work during any of the wiring conditions; however, only the Correct Wiring condition (both GREEN & BLUE LED's on) is optimal. Any other wiring condition should be corrected by Campground Maintenance before use.

Cautions

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, USE ONLY IN DRY LOCATIONS.

Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the electrical outlet and the electrical service panel.

This device features an internal protection that will disconnect the surge protective component but will maintain power to the load - now unprotected. If this situation is undesirable for the application, follow the manufacturer's instructions for replacing the device.

ATTENTION (French):

Pour réduire le risque d'électrocution, utiliser uniquement en intérieur sec. N'installez pas cet appareil si le fil entre la prise électrique et le panneau électrique est d'une longueur inférieure à 10 m (30 pi).

Ce dispositif est doté d'un système de protection interne qui désactivera le composant de suppression des surtensions. La barre d'alimentation continuera ensuite à laisser passer le courant, mais sans la protection contre les surtensions.

Si les appareils branchés nécessitent une protection contre les surtensions, suivez les directives du fabricant pour le remplacement du dispositif.

Manufacturer Information

Manufacturer: NINGBO LINSHENG ELECTRIC CO., LTD

Address: Xiao Dong Industrial Park, Yuyao, Zhejiang, China

Made In: China