Litetronics OLAPC1 3-Pin Photocontrol Installation Instructions

Instructions

Before installation, carefully remove all parts from the packaging. Inspect the product for defects due to shipping. Always turn off the power supply from the main circuit breaker first!

Photocontrol Installation

1. Turn off power.
2. The photocontrol should be installed on the back of the light. Replace the shorting cap with the photocontrol. (See Figure 1)
3. Ensure the installation is complete and secure before turning on the power.

Diagrams

Photocontrol Unit: A blue, compact, 3-pin photocontrol unit designed for lighting applications.

Figure 1: Area Light InstallationA diagram illustrating the installation of the photocontrol on an area light fixture. It shows the area light assembly, the photocontrol unit (labeled 'Photocell'), a socket, and a shorting cap. The instruction implies the shorting cap is removed and the photocontrol is inserted into the socket.

Flood Light InstallationA diagram showing a flood light fixture with a socket. It illustrates the photocontrol unit (labeled 'Photocell') being connected to this socket, alongside a shorting cap and the lamp.

Safety Instructions and Warnings

• When using electrical equipment, basic safety precautions should always be observed.
• This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
• Installation should only be conducted by a qualified electrician in accordance with NEC and any relevant local building codes.
• Be certain electrical power is OFF before and during installation and maintenance.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or sharp objects.

What Comes in the Box

• 3 Pin Photocontrol
• Installation Instructions