MP72 Customer Facing Scanner Installation Guide

Installing the Customer Facing Scanner

The Customer Facing Scanner (CFS) is an optional integrated device for the MP72 that supports scanning barcodes, coupons, and loyalty cards from customers' mobile phones and paper.

Mount the CFS on either side of the MP72 and connect it to the USB-A port on the main PCB on the bottom of the MP72.

Diagrammatic representation: An illustration shows the CFS unit being attached to the side of the MP72 device and its USB cable connecting to a port on the underside.

Installing the CFS Bracket

CFS bracket holes align with corresponding openings on the MP72 flange for the long configuration, or on the MP72 lower housing for the short and medium (flangeless) configurations.

Long (Flanged) Configuration

1. Remove the two screws on the MP72 flange.
2. Secure the CFS bracket to the flange using the two flange screws. Torque screws to 12 +/- 0.25 in-lb.

Diagrammatic representation: The process involves removing two screws from the MP72 flange, then attaching the CFS bracket to the flange with screws.

Short or Medium (Flangeless) Configuration

Place the spacer between the CFS bracket and MP72 chassis, and secure using the two screws provided with the CFS. Torque to 12 +/- 0.25 in-lb.

Diagrammatic representation: A spacer is positioned between the CFS bracket and the MP72 chassis, and then secured with two screws.

Replacing the Filler Cap

NOTE: The CFS kit includes left and right filler caps. Select the correct one according to the CFS mounting side, as shown in the installation diagrams.

1. Remove the MP72 filler cap mounting screw.
2. Remove the MP72 filler cap.
3. Insert the CFS filler cap and hold in place.
4. Install the filler cap screw and tighten until the filler cap is fully seated.

Diagrammatic representation: The steps include removing the filler cap mounting screw, detaching the existing filler cap, inserting the appropriate CFS filler cap (left or right), and re-securing it with the screw until fully seated.

Installing the CFS Pole and Cable

1. Route the USB cable from the CFS through the opening in the MP72, ensuring the cable is vertical in the pole slot.
2. Guide the CFS pole so the alignment pin on the pole enters the mating hole on the bracket.
3. Attach the two screws to mount the CFS pole to the bracket, and torque to 12 +/- 0.25 in-lb.
4. Route the USB cable towards the MP72, through an open guiding slot in the CFS mount, pulling the cable taught when routing so it remains in the CFS pole slot after installation.
5. Connect the USB cable to an open USB port.

NOTE: If the CFS is mounted on the opposite side of the MP72, the USB cable routes from the other direction.

Diagrammatic representation: This section illustrates routing the USB cable vertically within the MP72 pole slot, aligning the pole's pin with the bracket's hole, securing the pole with screws, carefully routing the cable through a guiding slot to keep it taut, and finally connecting it to a USB port on the MP72.

Support and Information

• View user documentation: zebra.com/mp72-info
• Join Community Connection of Zebra users and ambassadors: zebra.com/supportcommunity
• Contact Zebra about your product: zebra.com/contact
• View Quick Answers and Knowledge Base: zebra.com/knowledge
• Learn about product patent information: ip.zebra.com