MEEC TOOLS 2.5T Garage Jack

Product Description

A red, low-profile hydraulic garage jack designed for lifting vehicles. It offers a lifting capacity of 2.5 tons and a height range of 75-510 mm. The jack features double pistons for efficient operation and is built for durability and ease of use in automotive maintenance.

Image Description: A red, low-profile hydraulic garage jack with a lifting capacity of 2.5 tons. It features a long handle for operation and a saddle designed to lift vehicle chassis points. The jack has wheels for maneuverability.

Safety Instructions

• ⚠️ Never use the jack to lift people.
• Always center the load on the saddle before lifting.
• Never work under a vehicle unless it is securely supported by jack stands or equivalent.
• Always chock the vehicle's wheels and engage the parking brake.
• Do not push or lean on the vehicle when it is resting on the jack.
• Use only the lifting points specified by the vehicle manufacturer.
• Do not attempt to disassemble the jack, as this may cause damage or malfunction.
• Before each use, check that the jack is in good working condition.
• Do not attempt to lift or support foundations, houses, caravans, trailers, campers, or similar structures.
• This product is intended solely for lifting. Never attempt to move a vehicle while it is resting on the jack.
• Never overload the jack; this risks personal injury and/or property damage.
• Ensure the product is used on a hard, level surface capable of supporting the load. Using it on other surfaces can lead to instability and load collapse.
• Never position yourself under a vehicle supported only by the jack.
• Use only spare parts recommended by the manufacturer.
• Failure to follow all instructions and safety guidelines may result in personal injury or material damage.

Technical Data

Usage Instructions

IMPORTANT: Air in the hydraulic system can reduce performance. Bleed the product before first use.

Bleeding the Hydraulic System

To bleed the system: Open the lowering valve completely (turn handle counter-clockwise), press down the lifting saddle, and pump the handle rapidly several times.

Lifting

1. Close the lowering valve by turning the handle clockwise until it resists. Do not overtighten.
2. Position the jack under the object to be lifted. Ensure the center of the lifting saddle is directly under the lifting point. Lift the object slightly to verify correct saddle placement and check that the product or load cannot slip or move unexpectedly.
3. Lift the load by pumping the handle until the desired height is reached. Immediately support the lifted load with jack stands or equivalent. Never allow the load to rest solely on the jack.

Lowering

Turn the handle counter-clockwise slowly. The lowering speed depends on how much the valve is opened.

Maintenance and Storage

Storage: Always store the product in the fully lowered position with the handle upright.

Manufacturer and Contact

Manufacturer: Jula AB, Box 363, SE-532 24 SKARA, SWEDEN

For any issues, please contact the service department:

• Sweden: 0200-88 55 88, www.jula.se
• Norway: 67 90 01 34, www.jula.no
• Poland: 22 338 88 88, www.jula.pl
• International: www.jula.com

This product is CE marked, indicating conformity with relevant EU directives and standards, including Machinery Directive 2006/42/EC and EN 1494+A1:2008. The CE marking was applied in the year 2020.