SubZero Saturn 15VRH Amplifier Head
SZ-SATURN-15VRH
User Manual
Introduction
Thank you for purchasing the SubZero Saturn 15VRH amp head. To get the most out of your product, please read this manual carefully.
Box Contents
- SubZero Saturn 15VRH amplifier head.
- UK mains cable.
- EU mains cable.
Product Features
- All tube 15W architecture.
- Switchable 1W and 15W outputs.
- Reverb and effects loop.
- 3-Band EQ with shape control.
Specifications
| Input Power | 220-240VAC, 50/60Hz |
| Fuse | F1.6A, 250V |
| Power Consumption | 50W Max |
| Preamp Tube | 3x 12AX7 |
| Power Tube | 2x EL84 |
| Input Impedance | 1MΩ |
| Speaker Output | Max 15W RMS |
| Speaker Output Impedance | Minimum 8Ω |
| Frequency Range | 80Hz – 10kHz |
| S/N Ration | -75dB |
| THD | 0.5% |
| Dimensions | 436*242*204mm |
| Weight | 9.0kg |
Functions
The front panel features controls for your amplifier. The rear panel includes various connectors.
Front Panel Controls:
1. Input Connector: Connect your guitar using a 6.3mm TS jack cable.
2. High/Low Switch: Selects between 1W (low) and 15W (high) power output.
3. Reverb Control: Adjusts the amount of reverb. Fully anticlockwise adds no reverb.
4. Treble Control: Adjusts the amount of treble (high frequency) sent to the speaker output.
5. Middle Control: Adjusts the amount of mid-range frequency sent to the speaker output.
6. Bass Control: Adjusts the amount of bass (low frequency) sent to the speaker output.
7. Tone Control: Adjusts the amplifier's tone. Fully anticlockwise yields a thinner sound; fully clockwise yields a broader sound.
8. Volume Control: Controls the overall volume sent to the speaker output connector.
9. Gain Control: Increases input gain from the guitar. More gain results in a more distorted sound.
10. Standby Light: Illuminates when the amplifier is switched on.
11. Power Switch: Turns the amplifier on and off. Allow tubes to warm up before playing for increased lifespan and better sound.
Rear Panel Connectors:
12. Mains Power Connector: Connect the amplifier to mains power using the provided cable.
13. Reverb Footswitch Connector: Connect a one-button footswitch (6.3mm TS jack, not included) for remote reverb control.
14. Effects Loop (Return) Connector: Connect the output of an external effects processor using a 6.3mm TS jack cable.
15. Effects Loop (Send) Connector: Connect the input of an external effects processor using a 6.3mm TS jack cable.
16. Speaker Out Connector: Connect an external speaker using a 6.3 TS speaker jack cable. Note: This connection outputs at an amplifier level. Use a speaker jack cable capable of carrying the required load.
Safety Warnings
WARNING! Do not open cover. No user-serviceable parts inside. Refer servicing to qualified service personnel.
Do not place the product in a location near a heat source such as a radiator, or in an area subject to direct sunlight, excessive dust, mechanical vibration or shock.
The product must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the product.
No naked flame sources, such as lighted candles, should be placed on the product.
Support
If you have any more questions about this product, please do not hesitate to contact the Gear4music Customer Service Team on: +44 (0) 330 365 4444 or info@gear4music.com
