WALI 1330LM-PM Projector Mount Installation Manual

Important Safety Information

WARNING: Improper installation may cause damage or serious injury. If you do not understand these directions or have doubts about safety, call a qualified technician. Do not use this product for purposes not specified in this manual. Do not exceed weight capacity. Do not mount on drywall and/or vaulted ceilings.

TIPOVER WARNING: Serious or fatal crushing injuries can occur from tipover. To prevent tipover: NEVER allow children to climb, stand, hang, or play on any part of the projector mount. Use tipover restraint or anchor stand to wall. Use of tipover restraints may only reduce, but not eliminate the risk of tip over.

CAUTION: Small parts - not for children under 3 years. Adult supervision is required.

Supplied Parts List

• Wall Plate & Articulating Arms (x1)
• M6x35 Bolt & Washer (x1)
• Lag Bolt (x2)
• Concrete Anchor (x2)
• Lag Bolt Washer (x2)
• Lag Bolt Cover (x2)
• Universal Head (x1)
• Screw Adapter 1/4" to M4 (x1)
• Screw Adapter 1/4" to M6 (x1)
• Cable Tie (x3)

Tools Needed (Not Included)

• Stud Finder
• Bubble Level
• Pencil
• Electric Drill
• Socket Wrench
• Screwdriver

1. Wall Mounting

1a. Wood Stud Mounting

1. Mark the position with Bubble Level & pencil on the wall.
2. Drill 3/16" (4.5mm) diameter x 2.6" (65mm) length holes at the marked position.
3. Attach the bracket to the wall and tighten using Lag Bolt B and Lag Bolt Washer D with a socket wrench or screwdriver.

1b. Concrete Wall Mounting

1. Mark the position with Bubble Level & pencil on the wall.
2. Drill 3/8" (10mm) diameter x 2.6" (65mm) length holes at the marked position.
3. Insert the Concrete Anchor C into the mounting holes. Attach the bracket to the wall and tighten using Lag Bolt B and Lag Bolt Washer D with a socket wrench or screwdriver.

2. Attaching the Universal Head

1. Attach Universal Head F to Wall Plate & Articulating Arms ① using M6x35 Bolt & Washer A with a screwdriver.
2. Adjust the desired angle and tighten the thumb screw.

3. Select Projector Screws Adapter

Predetermine your projector's bolt type. Only one Screws Adapter size fits your projector.

• 3.2a: Screw adapter required
  Attach projector to the Spherical Universal Head using Screw Adapter 1/4" to M4 G or Screw Adapter 1/4" to M6 H.
• 3.2b: No Screw Adapter Required
  Attach projector to the Spherical Universal Head F.

4. Attach the Bolt Cover