BISSELL CleanView® Swivel Pet Rewind

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.

Always connect to a polarized outlet (one slot is wider than the other). Unplug from outlet when not in use and before conducting maintenance. When using an electrical appliance, basic precautions should be observed, including the following:

SAVE THESE INSTRUCTIONS

This model is for household use only.

What's In The Box?

Thanks for buying a BISSELL® vacuum!

We love to clean and we're excited to share one of our innovative products with you. We want your vacuum to work like new for the years to come, so this guide has tips on how to use, maintain and, if there's a problem, troubleshoot.

Your vacuum needs a little assembly before getting to work, so flip to the "Assembly" section and let's get started!

Product View

Handle

Pet TurboEraser® Tool

Tank Release Button

Carry Handle

Pre-Motor Filter (not shown)

Dirt Tank

Lifetime Post-Motor Filter

Swivel Steering

Height Adjustment

Edge Bristles

Stretch Hose

Suction Indicator

Pet Hair Corner Tool

Cord Rewind Button

Recline Pedal

Power Pedal

Dusting Brush Tool

Extension Wand

Power Cord

Assembly

The only tool you will need to assemble your vacuum is a Phillips-head screwdriver. ?

1. Place the Handle onto the base and push it down. Then attach the handle with the 2 screws taped to the handle in a plastic bag.

2. Insert the Extension Wand Base and turn it to the right to lock in place.

3. Insert the Stretch Hose end into the back of the vacuum and twist right to lock in place.

4. Wrap Stretch Hose up and around the hose wrap on the handle. Slide end of hose into vacuum base.

5. Now, put your accessory tools on the vacuum and you're ready to go!

   Dusting Brush

   Pet Hair Corner Tool

   TurboEraser® Tool

   Extension Wand (Crevice Tool stores inside)

Power ON & Settings

1. Press the red Power Pedal with your foot to turn the vacuum ON and once again to turn your vacuum OFF. ?

2. Press the Recline Pedal and pull handle back towards you. ↩️

3. Turn the dial on the foot of the vacuum to the desired setting. If the dial is difficult to turn, tilt the vacuum back slightly to take the weight off the foot while turning.

   • Lowest setting: For low pile carpet or bare floors. To pick up debris, it may be necessary to move up one setting.
   • Medium setting: For medium pile carpet.
   • Highest setting: For high pile and most shag carpet.

   TIP: For optimal carpet cleaning performance, adjust to the lowest practical setting. If your vacuum is difficult to push, adjust to the next higher setting.

Automatic Cord Rewind

1. To plug your vacuum in, gently pull the cord out of the automatic cord rewind and stop at the yellow mark on the cord. Do not pull past the red mark. Once you have the desired amount of cord, plug it into the outlet. ?

2. When you finish using your vacuum, unplug it from the outlet. Hold onto the plug and press the automatic cord rewind button until it's fully retracted. If the cord doesn't fully retract on the first try, pull a little bit of cord out and press the rewind button again. ⏪

Emptying the Dirt Tank

1. Empty once tank is full. ?️

2. Press the Tank Release Button and pull out to remove Dirt Tank. ➡️

3. Hold the Dirt Tank over a trash container. Press the bottom release button to empty. Once empty, close the lid. ?️

4. Twist cyclone left and pull down to remove from tank. ↩️

5. Clean cyclone with warm water and mild detergent. Let cyclone completely dry before replacing. To replace, fit into place and twist to the right. ?☀️

6. After emptied, place tank back on vacuum and press firmly until you hear “click”. ✔️

Cleaning the Pre-Motor Filter

1. Press the Tank Release Button and pull out to remove Dirt Tank. ➡️

2. Remove carbon and foam filter from lid. Hand wash in warm water and rinse well; mild detergent may be used if desired. ?

3. Allow filter to air dry completely before placing back into the tank lid. The carbon filter should be on top of the foam filter. ?️

4. Return tank back on vacuum and press firmly until you hear “click”. ✔️

Maintaining the TurboEraser® Tool

1. Twist gray collar counter-clockwise, until slot appears, then separate faceplate. ⚙️

2. Remove Brush Roll, belt, and paddle wheel. Inspect for damages and replace if necessary.

3. To reassemble, align two clips on each end of paddle wheel with belt on and pop back into place. Place Brush Roll with belt back in. Faceplate will not close properly if all parts are not aligned correctly.

Replacing the Brush & Belt

1. Unplug vacuum, turn over and unscrew six (6) Philips-head screws to remove the bottom cover. Lift brush straight out. ⬆️

2. Clean debris from Brush Roll. Inspect by placing on its end and spin. The Brush Roll should spin freely, multiple times by one flick. If it doesn't, replace Brush Roll. Check belt for wear or cuts and replace if necessary. ✨

3. Replace the Brush Roll and belt by looping the belt over the motor shaft and the Brush Roll. Line up the end caps and pull the brush forward into place. This will stretch the belt. Return bottom cover back on and replace the screws. ?

Clearing a Clog

1. Remove the Stretch Hose from the back of the vacuum by twisting it to the left. Remove any debris that may have gotten clogged. ?

2. Check the foot hose on the back of your vacuum down towards the bottom. If necessary, remove the screw from the foot hose and check for clogs.

3. Check the air passageway on the bottom of your vacuum. Remove the bottom cover and the brush. Remove any debris.

Troubleshooting

Warranty

This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Care by E-mail or telephone as described below.

It may be necessary to obtain some of your personal information, such as a mailing address, to fulfill terms of this warranty. Any personal data will be handled pursuant to BISSELL's Privacy Policy, which can be found online at www.BISSELL.com/privacy-policy.

Limited Four-Year Warranty

Subject to the *Exceptions and Exclusions from the Terms of the Limited Warranty, upon receipt of the product BISSELL will repair or replace (with new, refurbished, lightly used, or remanufactured components or products), at BISSELL's option, free of charge from the date of purchase by the original purchaser, for four years, any defective or malfunctioning part.

See information below on "If your BISSELL product should require service”.

This warranty applies to product used for personal, and not commercial or rental, service. This warranty does not apply to fans or routine maintenance components such as filters, belts or brushes. Damage or malfunction caused by negligence, abuse, neglect, unauthorized repair, or any other use not in accordance with the user guide is not covered. This warranty will only be valid if the product is used in the same country in which it was sold.

BISSELL is not liable for incidental or consequential damages of any nature associated with the use of this product. BISSELL's liability will not exceed the purchase price of the product.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

*Exceptions and Exclusions from the Terms of the Limited Warranty

This warranty is exclusive and in lieu of any other warranties, either oral or written. Any implied warranties, which may arise by operation of law, including the implied warranties of merchantability and fitness for a particular purpose, are limited to the four-year duration from the date of purchase as described above.

Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

Service

Please do not return this product to the store.

Other maintenance or service not included in the manual should be performed by an authorized service representative.

If your BISSELL® product should require service:

Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.

Register your product today!

Registering is quick, easy and offers you benefits over the lifetime of your product. You'll receive:

• BISSELL® Rewards Points: Automatically earn points for discounts and free shipping on future purchases.
• Faster Service: Supplying your information now saves you time should you need to contact us with questions regarding your product.
• Product Support Reminders and Alerts: We'll contact you with any important product maintenance reminders and alerts.
• Special Promotions: Optional: Register your email to receive notice of offers, contests, cleaning tips, and more!

Visit BISSELL.com/registration!

Parts & Supplies

For Parts and Supplies, go to www.BISSELL.com and enter your model number in the search field.

We're Waggin' Our Tails!

BISSELL® proudly supports BISSELL Pet Foundation® and its mission to help save homeless pets. When you buy a BISSELL product, you help save pets, too. We're proud to design products that help make pet messes, odors and pet homelessness disappear.

Visit BISSELLsavespets.com to learn more.

every purchase saves pets™ ?

Love your BISSELL® product?

Don't keep it a secret. Let us, and millions of others, know what you think! Leave your star-rating on BISSELL.com. ⭐