V-TAC LED Floodlight with Sensor - Installation Guide
Introduction & Warranty
Thank you for selecting and purchasing a V-TAC product. V-TAC is committed to serving you effectively. Please read these instructions carefully before installation and keep this manual for future reference. For any further queries, please contact your local dealer or vendor. The warranty is valid for 5 years from the date of purchase. It does not apply to damages caused by incorrect installation or abnormal wear and tear. The company is not liable for surface damages due to improper product removal or installation. Products are suitable for 10-12 hours of daily operation; 24-hour continuous use will void the warranty. This product is warranted for manufacturing defects only.
Warnings
- ⚠️ WARNING: Please ensure the power is turned OFF before starting the installation.
- Installation must be performed by a qualified electrician.
- The light source of this luminaire is not replaceable. When it reaches the end of its life, the entire luminaire must be replaced.
- If the external flexible cable or cord of this luminaire is damaged, it must be replaced exclusively by the manufacturer, their service agent, or a similarly qualified person to avoid hazards.
- Replace any cracked protective shield.
- Minimum distance from lighted objects: 1 meter.
- Terminal block is not included.
- Proper grounding must be ensured throughout the installation.
Features
- The sensor floodlight is convenient and easy to connect.
- Connect directly to the power supply like a normal floodlight.
- The light sensor functions automatically according to available daylight.
- When natural light is above 140 lux, the floodlight will automatically turn off. It will turn on automatically if natural light is below 140 lux.
- Manual switching of the light is not required.
- The light sensor may not operate as expected if it is obstructed or if motion is detected.
Technical Data
IP65 Rating
Light Sensor: Operates based on ambient light levels around 140 lux.
Installation Diagram
Figure 1: Shows the removal of a screw and bracket from the fixture.
Figure 2: Illustrates marking the hole positions on the wall for fixing the bracket. (Screw not supplied).
Figure 3: Depicts screwing the retaining bracket to the wall with appropriate screws.
Figure 4: Shows mounting the fixture back onto the bracket and tightening the adjustment screw.
Figure 5: Illustrates connecting the main cable to the product's input lead using a waterproof junction box. It highlights the connection of the line (-) wire.
Figure 6: Shows the final step of switching on the power to test the product and adjusting the direction angle.
Installation Instructions
- CAUTION: DO NOT USE IN AREAS WITH LIMITED VENTILATION OR OUTSIDE THE RATED AMBIENT TEMPERATURE RANGE.
- Connect only with waterproof cable housing.
- Ensure electricity is switched OFF before installation.
- Please do not mount to a surface that is prone to vibrations.
- Step 1: Remove the screw and the bracket afterward (Figure 1).
- Step 2: Before drilling, mark the hole position for fixing the bracket onto the wall (Screw not supplied) (Figure 2).
- Step 3: Screw the retaining bracket to the wall with a suitable quantity of screws (Figure 3).
- Step 4: Mount the bracket back to the fixture. Adjust the floodlight according to the desired position. Tighten the screw (Figure 4).
- Step 5: Connect your main cable (H05RN-F3G1.0mm² Recommended) with the input lead of our product through the waterproof junction box. Note the line (-) of the lead (Figure 5). Ensure to use a junction box rated IP65 or above and tighten the waterproof screw securely.
- Step 6: Switch on the power to make sure the product is working. Adjust the direction angle as per your preference (Figure 6).
Disposal Information
This marking ♻️ indicates that this product should not be disposed of with other household wastes.
