Ledvion LED DIMMER
Manual for LED dimmer switch
Model: LV10001_1
LEDVION DIMMER:
This RC dimmer has been developed specially for dimmable LED lamps. Additionally, the minimum brightness setting of the dimmer can be adjusted to achieve the optimum dimming range for a particular load. Keep these instructions for reference if you change your lights to a different type at a later date.
TECHNICAL DATA:
| Operating Voltage | 220-240V ~ |
|---|---|
| Frequency | 50Hz |
| Max. light sources | 20* (multiple LEDs possible per driver) |
| Max. number of LED drivers | 20* |
| Maximum load | 300W/VA/Pf ≥ 0.90 |
| Minimum load | 10W |
| Dimming mode | Trailing edge / RC |
| Control method | Two way |
| Ambient temperature | <60°C (T amb = 60°C) |
| Dimmable LED lamps | 5-150W/VA |
*NOTE: When using high quality LED drivers with low inrush currents
WARNING!
Certain light sources may not behave according to their power rating when used with a dimmer. An overload will result in the safety feature switching the dimmer off. It is always recommended to connect under the suggested load.
INSTALLATION:
- Make sure the electricity is switched off before any operation. Connect the wire as shown in the "wire connection" diagram.
- Install the dimmer into the junction box.
- Switch on electricity. Push the shaft button to ON or OFF, and turn the shaft to adjust the dimming brightness. When lamps are flashing, adjust the min setting to the minimum brightness level to make lamps stable.
- When all settings are finished, fit the dimmer in the wall. Cover the frame and the dimmer knob on the dimmer.
*If the dimmer is overloaded and gets too hot, the dimmer will start its protection function and stop working. After solving the issue, wait 5 minutes, then push the rotary to reset the dimmer. The dimmer will then work again.
MIN. BRIGHTNESS SETTING
To set the min. brightness to avoid flickering or satisfied min brightness:
- Ensure the lamp module is switched ON.
- Turn the knob anti-clockwise.
- Turn the VR (Variable Resister) clockwise.
- Turn the VR anti-clockwise to decrease the brightness at the min. & max. point.
Diagram showing dimmer dimensions and MIN/MAX settings:
[Diagram: A circular dimmer knob with MIN and MAX indicators. A central shaft is shown. Dimensions 70.00mm are indicated. A small circular VR (Variable Resister) is also depicted.]
WIRING CONNECTION:
ONE-WAY CONNECTION
[Diagram: Shows a single-way wiring connection with L (Live) and N (Neutral) terminals connected to the dimmer.]
TWO-WAY CONNECTION
[Diagram: Shows a two-way wiring connection with L (Live) and N (Neutral) terminals connected to the dimmer, along with two-way switch connections.]
Compliance and Safety Information:
CE: This device is in compliance with EN 60669-2-1.
- Should not be disposed of with other household wastes.
- This product is not a toy. Keep away from children and animals.
- Do not expose this product to moisture, water, or other liquids.
- Do not attempt to examine or repair this product yourself.
- This product is designed for indoor use only. Do not use outside!
