Anker 535 Portable Power Station (PowerHouse 512Wh)

Overview

Handle: The carrying handle for portability.

LCD Screen: Displays battery status, input/output power, and other information.

LCD Screen On/Off Button: Turns the LCD screen on or off.

Ambient Light On/Off Button: Controls the ambient light feature.

Car Socket: A 12V DC socket for car accessories.

Car Socket On/Off Button: Powers the car socket on or off.

DC Input Port: Port for recharging the power station.

AC Output Port: Standard AC outlets for powering devices.

Power Saving Mode On/Off Switch: Activates or deactivates power saving mode.

USB-A Output Port: Standard USB-A ports for charging devices.

USB-C Input/Output Port: Versatile USB-C port for charging and output.

Recharging Your Power Station

The power station can be recharged using various methods:

• 60W Charging: Using a 60W power adapter.
• 120W Charging (via USB-C): Using a 120W USB-C charger.
• 180W Charging: Using a 180W power adapter.
• 120W Charging (via Car Socket): Using a 120W car charger.
• 120W Charging (via Solar Panel): Connect a compatible solar panel (12V-28V, with DC 8mm connector).

Important Notes:

• The power station is shipped with its battery deactivated to prevent overdischarge. Charge it fully before first use.
• When the battery level drops to 1%, the remaining battery indicators will flash to remind you to recharge.

Powering Your Devices

The power station can power various devices through its ports:

• USB-A and USB-C Ports: Support plug-and-charge. Devices start charging automatically when connected and stop when unplugged.
• Car Socket and AC Output Ports: Require the corresponding on/off buttons to be activated before charging.

Power Saving Mode: It is recommended to keep Power Saving Mode enabled to conserve battery, except when charging low-power devices like CPAP machines and cameras.

LCD Screen Guide

The LCD screen provides the following information:

1. Power Saving Mode Icon: Indicates if power saving mode is active.
2. High-Temperature Alert: Appears when the product is too hot. Stop use until the icon disappears.
3. Low-Temperature Alert: Appears when the product is too cold. Stop use until the icon disappears.
4. USB-C Input/Output Port Indicator: Shows activity on the USB-C port.
5. USB-A Output Indicator: Shows activity on the USB-A ports.
6. Car Charging Indicator: Shows when charging via the car socket.
7. AC Charging and Voltage Frequency: Displays AC input status and allows switching between 50Hz and 60Hz by pressing the AC output port on/off button for 2 seconds.
8. Remaining Battery: Shows the current battery percentage.
9. Recharge Hours / Remaining Hours: Estimates the time to fully recharge or the remaining usage time.
10. Current Input Power: Displays the power being received by the power station.
11. Current Output Power: Displays the total power being drawn by connected devices.

Flashlight Mode

• Press the button once to turn on the ambient light.
• Hold the button for 2 seconds to turn on SOS mode.

Trouble Shooting

Resetting Your Power Station

If the power station is not working correctly, insert a paper clip or pin into the reset hole for 1 second for a factory reset. If the issue persists, contact support@anker.com.

FAQ

• Q1: What's the max power output of the AC port?
  500W. The product will automatically turn off if devices exceeding 500W are connected.
• Q2: Can I recharge the product while charging connected devices?
  Yes.
• Q3: Can this product power a CPAP?
  Yes, but ensure Power Saving Mode is turned off first.
• Q4: Will this product lose power automatically if not powered off?
  Yes, if the car socket or AC control button is on, there will be a no-load power consumption. To prevent battery drain, it's recommended to keep Power Saving Mode on, except when charging low-power devices like CPAP machines and cameras.
• Q5: What kind of solar charger can charge this product?
  Any 12V-28V solar charger with a DC 8mm (DC 7909) male connector.

Specifications

Attention: Not permitted on aircraft. ✈️

Important Safety Instructions

WARNING: When using this product, basic precautions should always be followed:

• Read all instructions before use.
• Keep out of reach of children.
• Do not insert fingers or hands into the product.
• Do not expose to rain or snow.
• Use only manufacturer-recommended power supplies or chargers to avoid fire or injury risks.
• Pull the plug, not the cord, when disconnecting to prevent damage to the plug and cord.
• Do not exceed the product's output rating to avoid fire or injury risks.
• Do not use damaged or modified products, as they may exhibit unpredictable behavior.
• Do not use with a damaged cord, plug, or output cable.
• Do not disassemble the product. Seek qualified service personnel for repair to avoid risks of fire or electric shock.
• Do not expose to fire or high temperatures (above 130°C) as it may cause explosion.
• Unplug from the outlet before servicing to reduce the risk of electric shock.
• Have servicing performed by qualified personnel using identical replacement parts.
• The product may feel warm during charging, which is normal. Ensure good ventilation when charging the internal battery.
• Do not clean with harmful chemicals or detergents.
• Avoid misuse, dropping, or excessive force, which may cause product damage.
• Keep batteries of different electrochemical systems separate when disposing of them.

Storage and Maintenance Instructions

1. Store the product between 32°F-104°F (0°C-40°C). Avoid exposure to rain or humid environments.
2. To preserve battery lifespan, discharge to 30% and recharge to 60% every three months.
3. For safety, do not store the product in environments above 113°F (45°C) or below 14°F (-10°C) for extended periods.
4. Keep the product laid flat during use, charging, and storage.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.

The following importer is the responsible party:

Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1-800-988-7973

IC Statement

This device complies with Industry Canada license-ICES-003. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

This digital apparatus complies with CAN ICES-3(B)/NMB-3(B).

Declaration of Conformity

Anker Innovations Limited declares that the product type A1751 is in compliance with Directives 2014/35/EU & 2014/30/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at: https://www.anker.com

GB Declaration of Conformity

Anker Innovations Limited declares that the product type A1751 is in compliance with Electrical Equipment (Safety) Regulations 2016 & Electromagnetic Compatibility Regulations 2016 & The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012. The full text of the GB declaration of conformity is available at: https://www.anker.com

Anker Innovations Limited | Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

Importer (EU and UK):

Anker Innovations Deutschland GmbH | Georg-Muche-Strasse 3, 80807 Munich, Germany

Anker Technology (UK) Ltd | Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United Kingdom

Customer Service

Warranty: 24-month limited warranty (extensions available).

Technical Support: Lifetime technical support.

Email:

• support@anker.com
• support.mea@anker.com (For Middle East and Africa Only)

Contact Numbers:

• (US/CA) +1 (800)988-7973 (Mon-Fri 6:15AM - 5:00PM PT)
• (UK) +44 (0) 1604 936200 (Mon-Fri 6:00-17:00; Sat-Sun 6:00-14:00)
• (DE) +49 (0) 69 9579 7960 (Mon-Fri 6:00 - 11:00)
• (Middle East & Africa) +971 42428633 (Mon-Fri 9:00 - 17:30)
• (UAE) +971 8000320817 (Mon-Fri 9:00 - 17:30)
• (KSA) +966 8008500030 (Mon-Fri 8:00 - 16:30)
• (Kuwait) +965 22069086 (Mon-Fri 9:00 - 17:30)
• (Egypt) +20 8000000826 (Mon-Fri 7:00 - 15:30)
• (AU) +61 3 8331 4800 (Mon-Fri 8:30 - 17:00 AEST)
• (TR) +90 (850) 460 14 14 (Mon-Fri 9:00 - 18:00)
• (RU) +8 (800) 511-86-23 (Mon-Fri 9:00 - 18:00 MSK)
• (China) +86 4000550036 (Mon-Fri 9:00 - 17:30)
• (Japan) 0344557823 (Mon-Fri 9:00 - 17:00)
• (Korea) +82 02-1670-7098 (Mon-Fri 10:00 - 17:00)