HOMCOM 839-622V00 / 839-622V70 2-Seater Sofa

Important Information

IMPORTANT: RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.

Thank you for purchasing this product. So that your appliance serves you well, please read all the instructions in this user's manual. If you have any questions, please contact our customer care center.

Product Overview

This manual provides instructions for the HOMCOM 2-Seater Sofa.

For domestic use only.

Instructions for Use

• Place the sofa stably on a flat floor.
• Ensure the sofa is assembled in good condition.
• Stay away from open flames.
• Avoid overloading the sofa.

Precautions Before Assembly

• Prepare a clean and dry mounting area.
• Verify that the product is not damaged.
• Check that none of the pieces are missing.

Maintenance

• Clean with a soft fabric.
• Regularly remove leaves and / or water collected on the fabric.
• Check the seating regularly for stability.

Storage Conditions

• To prevent mold, the fabric should be stored completely dry, in a clean and dry place.

Safety Warnings

Beware of crushing and cutting hazards during assembly.

The manufacturer declines all responsibility in case of damages due to bad installation or environmental factors.

If the sofa is fitted with powered seat height adjustments, only trained personnel may replace or repair those components.

Assembly Guide

Parts List:

• A: Seat Cushion (x1)
• B: Back Cushion (x1)
• C: Backrest (x1)
• D: Base Frame (x1)
• E: Armrests (x2)
• F: Seat Base Panels (x2)
• G: Support Brackets/Legs (x4)

Hardware List:

• H: M8*45 bolts (x5 + 1 spare)
• I: M8*50 bolts (x8 + 1 spare)
• J: M6*20 bolts (x12 + 1 spare)
• K: Φ30 Washers (x5 + 1 spare)
• L: Φ22 Washers (x8 + 1 spare)
• M: M Washers (x5 + 1 spare)
• N: Allen Key (x1)

Assembly Steps:

1. Step 01: Attach the four support brackets/legs (G) to the underside of the base frame (D) using twelve M6*20 bolts (J) and the provided Allen key (N).

   Diagram shows base frame (D) with four legs (G) being attached using bolts (J) and Allen key (N).

2. Step 02: Secure the backrest (C) to the base frame (D). Use five M8*45 bolts (H) with five Φ30 washers (K) and five M washers (M) on each side where indicated, tightening with the Allen key (N).

   Diagram shows backrest (C) being attached to the base frame (D) using bolts (H), washers (K), and M, secured by Allen key (N).

3. Step 03: Attach the two armrests (E) to the sides of the backrest (C) and base frame (D). Use eight M8*50 bolts (I) with eight Φ22 washers (L) to connect the armrests to the main structure, tightening with the Allen key (N).

   Diagram shows armrests (E) being attached to the backrest (C) and base frame (D) using bolts (I) and washers (L), secured by Allen key (N).

4. Step 04: Slide the two seat base panels (F) into the designated slots on the frame.

   Diagram shows seat base panels (F) being inserted into the assembled frame.

5. Step 05: Place the seat cushion (A) and the back cushion (B) onto the assembled sofa frame. The assembly is now complete.

   Diagram shows seat cushion (A) and back cushion (B) being placed on the sofa. Final image shows the completed sofa.