PWF2700SH Pressure Washer Quick Start Guide
This guide provides essential steps for assembling, starting, and stopping your AIPower PWF2700SH pressure washer.
Before Starting
Important: READ AND FOLLOW OWNER'S MANUAL PRIOR TO USE.
Failure to read and follow instructions in the manual(s) could result in death, bodily injury, and/or property damage.
Assembly
Follow these steps to assemble your pressure washer:
- Assemble the handle.
- Attach the gun holder to the handle.
- Attach the hose holder to the panel.
Connections
Connect the necessary components:
- Connect the pressure hose to the pump.
- Connect the pressure hose to the spray gun.
- Connect the wand to the spray gun.
- Attach the nozzle to the wand via the quick connect fitting.
Available nozzles and their spray patterns:
- 0° (Red) - High impact, for tough stains.
- 15° (Yellow) - Medium impact, for general cleaning.
- 25° (Green) - Wider spray, for moderate cleaning.
- 40° (White) - Broadest spray, for rinsing and delicate surfaces.
Starting the Engine
- Connect to a water source and turn the water ON.
- Set the choke position: Use 'ON' to start a cold engine, 'RUN' to restart a warm engine. Open the fuel valve.
- Turn the engine switch ON.
- Pull the recoil handle until the engine starts.
- Once the engine starts, move the choke lever slowly to the 'RUN' position.
For applying soap and detergent, follow specific instructions in the owner's manual.
Stopping the Engine
- Lock the gun trigger.
- Turn the engine switch OFF.
- Turn the choke lever and fuel valve lever OFF.
- Turn the water spigot OFF.
- Release any residual pressure from the system.
Support
❓ Have questions? Call 1-855-888-3598 or email support@a-ipower.com.