Aigostar Ceiling Fan with Light - Instruction Manual
Important Safety Instructions
The information contained herein has been prepared to ensure you of trouble-free operation of this product. Read instructions carefully for safe installation and operation.
- Before performing any electrical connection or cleaning operation on the device, ensure that the general power supply of the installation is disconnected and turned off by removing the corresponding fuses or protective switches installed for 'disassembly', to ensure complete isolation of the power supply.
- The installation must be carried out by qualified personnel in accordance with the current national standards for electrical installation. Remember to ask the installer to test all fan functions. If you have any questions about the installation process, please contact us.
- You must ensure that the mounting bracket is securely fixed to the roof structure using screws that can withstand a weight of at least 30 kg. The screws must be at least 30 mm in length and properly threaded into the ceiling. If the fan is installed on a roof junction box, the fan bracket must be securely fixed to prevent the fan from becoming loose or rotating.
- The method for fixing the fan bracket to the ceiling will vary depending on the type of ceiling where the installation is located. The installer is responsible for determining which fixing system to use and how many to use.
- Do not insert any objects that may come into contact with the fan blades during rotation, as this could cause injury to people. Damaged blades and unbalanced units can cause vibration and swinging.
- If the power cord is damaged, it must be replaced by the manufacturer, its after-sales service, or similar qualified personnel to avoid danger.
- For optimal use, this product should be used in a dry indoor environment as it is not waterproof.
- The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Specifications
This product contains a light source of energy efficiency class
| Input voltage | 220-240V~ |
| Frequency | 50/60Hz |
| Power of the lamp | 40W |
| Luminous flex | 4400lm |
| Color temperature | 2700-6500K |
| Power of the fan | 20W |
| Fan speed levels | 6 |
| Remote control distance | 8-10 m |
Product Overview
A diagram shows the dimensions of the ceiling fan: 180mm diameter for the central unit, 480mm overall diameter, and 155mm height.
Installation Instructions
-
Step 1: Install the wall plug.
Note: Please turn off all switches and ensure there is no power supply during installation. If the roof is made of concrete, drill four holes according to the position of the holes on the mounting plate, and then insert the wall plug. If the roof is made of wood, this step is not necessary.
-
Step 2: Install the plate.
Thread the power cord through the holes on the mounting plate and secure it at the top with four wooden screws.
-
Step 3: Install the motor.
Hang the safety rope of the fan onto the hook on the mounting plate.
Connect the yellow-green ground wire to the ground wire. Connect the blue wire to the zero wire. Connect the brown wire to the fire wire.
Clip the keyhole on the fan connection plate into the two screws on the mounting plate. Then tighten the four screws.
Remote Control Instructions
The installation is done and turn on the power for use.
- Open the battery cover of the remote control and insert two 1.5V AAA batteries. Then, close the battery cover.
- Remote control pairing code: Turn on the power, and press the pairing code button [pairing-code-button] within 5 seconds until you hear a "beep".
A diagram shows the remote control with buttons for indicator light, fan speed, wind speed, light on/off, brightness, color temperature, natural wind, all off, pairing code, forward/reverse, and timer.
Notes:
- After setting the timer, please do not press any buttons on the remote control, otherwise the timer will be canceled.
- If the remote control is not used for a long time, please remove the batteries.
