Transport Protection
Remove the transport protection between the load dish and the upper part of the housing.
Battery
Two AAA batteries are included. The battery compartment is on the base of the scales. Please note polarity marking. Before using the scales remove the plastic protection.
Positioning the Scales
Please ensure that the scales is in a horizontal position.
Weighing (ON)
After switching on the scales with the “ON/OFF/TARE” key, “8888” appears in the display. Please wait until zero appears. Then place the weight on to the scales and read off the weight.
Net Weighing (TARE)
Place an empty container (i.e. first weight) on to the scales and then subtract this weight by pressing the “ON/OFF/TARE” key until zero appears. Fill the container (i.e. add second weight to the scales). Only the additional weight is indicated in the display.
Switch off (OFF)
Press the key “ON/OFF/TARE” until the display disappears. Automatic switch-off will occur after approx. 1,5 minutes, if no change of weight occurs in this time.
Switching the weight units g, lb:oz ml or fl oz
The scale can show the weight value in g, lb:oz, ml or fl oz. Change between the weighing mode g and lb:oz: Press a long time (> 3 sec.) the “UNIT” button when the scale is turned on. Change between the measuring mode of volume ml or fl oz: Press shortly ( < 1 sec. ) the “UNIT” button.
Explanation of the special symbols
1. Switching on
After pressing the “ON/OFF/TARE”- key all symbols appear. You can check whether all segments are clearly shown on the display. Zero indicates that the scales are ready for operation.
2. Negative value
Press the “ON/OFF/TARE”- key once again.
3. The indication of the weight is not stable
If the display shows “unSt”, the scale is not placed on a steady surface.
4. Overload
If the weight exceeds the total weighing capacity of the scales, “Err” appears in the display.
5. Energy Supply
If “Lo" appears on the display, the batteries need to be changed.
Precision
This device corresponds to requirements stipulated in 2014/31/EU. Every scale has been carefully calibrated and controlled during the production process. The tolerance is ± 0,5% ± 1 digit (at Temperatures between +5° and +35° C). Incorrect display values due to damage attributable to impropera handling, mechanical damage or malfunction is exempt from liability. Damages due to faults are also exempt from the guarantee. No liability is accepted for consequential damages or losses by the buyer or the user.
Compliance and Notes
This device complies with the requirements of EC Directive 2014/31/EU.
Note: Unusual electro-magnetic influences (jammers in the immediate vicinity) may affect the display value. After the end of the interference period, the product can be used again as intended. These scales cannot be used for official metrology.
