HALO Pocket Power™ 2200 Guide

This guide provides instructions for using the HALO Pocket Power™ 2200 charger.

Included Items

Getting Started

Charge the HALO Pocket Power™ charger until the LED displays solid Green (no lights should be flashing). This will take up to 6 hours and will fluctuate depending on the charging power source.

Figure 1: Halo Charge it Charge Me 2in1 USB Cable

A diagram showing the HALO Charge It Charge Me™ 2in1 USB Cable with connectors labeled A and B.

Step 1: Charge the HALO Pocket Power™ charger

Using the supplied HALO Charge It Charge Me™ cable, plug one USB connector into the Halo charger and plug the other USB connector to a computer or an AC power source with a USB 5V input. The charging cable works in either direction.

During charging, the LED will flash the following color indicating charge level: Red (1%-33%), Yellow (34%-66%), Green (67%-99%). When the charger is 100% fully charged, the Green LED will become illuminated and will no longer flash.

Step 2: Charge your Personal Electronic Device

Using the supplied HALO Charge It Charge Me™ cable, plug one USB connector into the HALO Pocket Power™ charger, and insert the provided appropriate tip into your device. The HALO Pocket Power will automatically begin charging. You may also use your own USB cable that was supplied with your personal electronic device.

The LED color will change over time, indicating the remaining capacity as the HALO Pocket Power discharges. The Red LED will start flashing when the HALO Pocket Power™ charger is out of power before shutting down.

NOTE: Using the supplied HALO Charge It Charge Me™ cable, you can charge both the HALO Pocket Power™ charger and your electronic device at the same time. To do this, first plug either USB connector into a computer (or another 5V input USB charging source), and then connect the Halo charger and your electronic device.

IMPORTANT NOTE: When using the supplied 30-pin connector tip, the HALO Pocket Power™ will remain on for 15 seconds after removing your device from the connector before powering off. If you wish to charge your device again after the HALO Pocket Power™ has timed off, you must manually power ON the HALO Pocket Power.

To Turn ON/OFF the HALO Pocket Power

The HALO Pocket Power is equipped with intelligent software to turn ON the Halo Pocket Power™ charger automatically when a USB cable is inserted AND an electronic device is connected and drawing power within 15 seconds of inserting the USB cable. If the electronic device is fully charged and no longer drawing power, the HALO Pocket Power will automatically turn OFF to preserve battery.

NOTE: The unit may also manually be turned ON/OFF by depressing the power button for 3 seconds.

Power Indicator/Status

The LED display will provide the current battery level while the unit is ON. To determine how much battery remains while the unit is OFF, simply press and quickly release the power button. In this mode, the LED lights will not flash but will illuminate and display the current power level: Red (1%-33%), Yellow (34%-66%), Green (67%-100%).

Storing the HALO Pocket Power

Please keep the unit out of extreme temperature conditions and do not get wet.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

15.21: You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

15.105(b): This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Limited Warranty

Halo2Cloud, LLC warrants its products to be free from defects in material and workmanship under normal use conditions, as follows:

The warranty does not extend to the electronic equipment that is used or which incorporates with any of our products and accessories. Halo2Cloud, LLC shall not be held responsible for the improper use of its products.

To contact us call (888) 907-6274

Made in China

Patents Pending

CEFC

HALO2CLOUD, LLC

148 EASTERN BOULEVARD, GLASTONBURY, CT 06033 USA 860-633-0882 HALO2CLOUD.COM

PDF preview unavailable. Download the PDF instead.

halopocketpower2200operatinginstructions Adobe Illustrator CS5.1 Adobe PDF library 9.90

Related Documents

Preview HALO Bolt 58830 ACDC Quick Start Guide
Get started quickly with the HALO Bolt 58830 ACDC portable power bank. This guide covers jump-starting vehicles, charging laptops and electronic devices, and using the integrated LED floodlight. Features include USB ports, an AC outlet, and a car jump starter function.
Preview HALO BOLT ULTIMATE 3.0 User Manual - Portable Jump Starter & Power Bank
Detailed user manual for the HALO BOLT ULTIMATE 3.0, a portable jump starter and power bank. Includes safety guidelines, product overview, charging instructions, jump starting procedures, air compressor functions, device charging, laptop charging, troubleshooting, and technical specifications.
Preview HALO RapidPack 10K Portable Charger: Operating Instructions and Specifications
User manual for the HALO RapidPack 10K portable power bank. Includes setup, charging instructions, device specifications, safety precautions, warranty information, and FCC compliance details.
Preview HALO Hub-Link 5K Power Bank Owners Manual
Owners manual for the HALO Hub-Link 5K Power Bank, including safety instructions, product overview, charging instructions, troubleshooting, and technical specifications.
Preview HALO BOLT ACDC 58830 User Manual and Operating Guide
Comprehensive guide to operating, charging, and jump-starting vehicles with the HALO BOLT ACDC 58830 portable power station. Includes safety precautions, specifications, and troubleshooting.
Preview HALO RapidPack 10K Wireless: Operating Instructions and Safety Guide
Comprehensive operating instructions, safety precautions, specifications, and warranty information for the HALO RapidPack 10K Wireless portable power bank. Learn how to charge your devices and use the wireless charging feature safely.
Preview HALO ULTRAPACK 20000 Operating Instructions and Specifications
Comprehensive operating instructions, safety precautions, specifications, and warranty information for the HALO ULTRAPACK 20000 portable charger by HALO.
Preview HALO 2.5K Emergency Power Bank User Manual
User manual for the HALO 2.5K Emergency Power Bank, covering safety instructions, product maintenance, overview, charging procedures, product registration, and technical specifications.