Tristar VE-5841 Portable Fan
User Manual
Safety Precautions
- Choose the place for the device carefully. The surface used for the device must be dry and of normal temperature (not hot) and must not be next to a heat source (heating surface) or source of water.
- Check the USB charging cable, connectors, adapter (which can be bought additionally) and plug before connecting the device to the adapter and the adapter to the plug (power supply). If you observe any defect, contact the support department.
- Only use a dry or slightly damp cloth to clean the device.
- Use the device exclusively for the purposes described in the instructions for use.
- If the USB charging cable is damaged, the manufacturer, authorized repair service, or similarly qualified personnel must replace it to prevent any danger.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- The warranty is void in the following cases:
- An unauthorized or unqualified person attempts to repair the device.
- The device is used for purposes other than intended.
- Safety rules and instructions for use are not followed.
- Never use the device in an explosive atmosphere.
- Store the device in dry spaces at room temperature.
- When correctly connected and used in accordance with the instructions, the device is not dangerous. Electrical components use low voltage and are protected against dust.
- Read the instructions for use thoroughly before use.
- Opening the device and accessing its interior by a user is forbidden.
- The manufacturer assumes no liability for damage caused by incorrect use or by failure to comply with the instructions.
- Do not use this fan in the immediate surroundings of a bath, a shower or a swimming pool. Never locate the fan where it may fall into the bath tub or other water container.
- Never insert fingers, pencils, or any other object through the guard when the fan is running.
Parts Description
The fan unit includes the following parts:
- 1. Fan
- 2. Charging light
- 3. Speed indication lights
- 4. Button: on/off, speed adjustment, oscillation
- 5. USB cable
[Diagram shows a white portable fan with a base and a fan head. The USB cable is shown connected to the back of the base. Numbered callouts point to the fan, charging light, speed lights, and the control button.]
Before First Use
- Take the appliance and accessories out of the box. Remove any stickers, protective foil, or plastic from the device.
- Before using your appliance for the first time, wipe off all removable parts with a damp cloth. Never use abrasive products.
- Place the appliance on a flat, stable surface and ensure a minimum of 10 cm free space around the appliance. This appliance is not suitable for installation in a cabinet or for outdoor use.
Charging the Fan
- This product contains a built-in lithium-ion battery, which must be charged before use.
- Connect the supplied USB cable to the micro USB port at the back of the fan base and the USB connector end to a powered USB port (e.g., on a mobile adapter, computer, or laptop).
- During charging, the indicator light will flash red. After the appliance is fully charged, the indicator light will be solid red. A full charge takes approximately 4 to 5 hours.
- When charging is finished, disconnect the USB cable.
- The fan can be operated during charging; the charging indicator light will flash red, and the speed indicator light will be blue.
Operation
- Press the button on the base to choose the fan speed from 1 to 4.
- Press the button once: Speed 1, one light is on.
- Press the button twice: Speed 2, two lights are on.
- Press the button three times: Speed 3, three lights are on.
- Press the button four times: Speed 4, four lights are on.
- Press the button five times: Turn off the fan.
- Oscillation function: When the fan is on, press and hold the button for 3 seconds to start oscillation. Press and hold the button again for 3 seconds to stop oscillation.
Cleaning and Maintenance
- Before cleaning, unplug the adapter.
- Store the USB charging cable and the device in a dry and ventilated place.
- Use a soft, dry, or slightly damp soft cloth to clean the device. Do not use sponges, coarse cloth, polishing agents, disinfectants, or aggressive cleaning agents that may damage the surface of individual components. Never immerse the device in water or put it under running water. Never spray cleaning agents directly on the inside or outside of the device.
- The device must be completely dry before use. If liquid enters the interior of the device, consult the seller or authorized repair service.
- Keep the air vents free from dust.
- Use a vacuum cleaner to remove dust when necessary.
Environment
This appliance should not be disposed of with domestic garbage at the end of its lifespan. It must be offered at a central point for the recycling of electric and electronic domestic appliances. This symbol on the appliance, instruction manual, and packaging draws your attention to this important issue. The materials used in this appliance can be recycled. By recycling used domestic appliances, you contribute significantly to the protection of our environment. Ask your local authorities for information regarding collection points.
The European directive for batteries (2006/66/EC) states that it is not permitted to throw batteries away with household waste. They may contain substances that are harmful to the environment. Empty batteries can be handed over to a local, public collection point or a local recycling center. To avoid overheating as a result of a short circuit, lithium batteries must be removed from the product and the poles must be protected using insulation tape or some other means against short-circuiting.