Joie Commuter™ Travel Cot

Instruction Manual

Suitable for: Birth to 15kg

Important Safety Information

Do not use a mattress other than the one supplied by the manufacturer. Incorrect mattress can cause death.
Use only accessories as recommended by the manufacturers.
Ensure the top rails and base are fully locked.
Stop using this cot if any part of the cot is broken, torn, or missing.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
NEVER PLACE A CHILD IN THE COT WHEN THE CHANGER TABLE IS IN PLACE.
ALWAYS USE THE HARNESS WHEN USING THE CHANGER TABLE.
NEVER PLACE A CHILD IN THE COT WHEN THE BASSINET IS IN PLACE.
TO PREVENT FALLS, THE BASSINET MUST NOT BE USED ONCE A CHILD CAN SIT UP.
THIS BASSINET SHOULD BE REMOVED BEFORE THE CHILD CAN SIT UP.
Keep children away while assembling/disassembling the cot.
Do not leave anything on the folding cot (such as toys) that provide a foothold.
Do not use the folding cot near naked heat sources, bar heaters, open fires or exposed flames.
Keep the folding cot clear of trailing cables and hanging cords.
Keep medication and small items that a child could choke on, away from the cot.
The folding cots with padded rims should not be used if the covering material has been bitten through.
All assembly fittings should always be tightened properly and that fittings should be checked regularly and retightened as necessary.
NEVER LEAVE CHILD UNATTENDED. Always keep your child in view.
Always use on a flat, level floor.
Only use the mattress sold with this cot; do not add a second mattress on this one, as this poses suffocation hazards.
To avoid suffocation, remove plastic bag and packaging materials before using this product. The plastic bag and packaging materials should then be kept away from babies and children.
Check that the assembly of the folding cot is correct and safe.
Check that the locking devices are fully engaged.
Carry out the assembly of the folding cot in a particular order.
Secure, tighten, and maintain all fastening devices.
The bassinet can not be used separately. The bassinet needs to be used with the mainframe sold together.

Welcome to Joie

Congratulations on becoming part of the Joie family! Joie is excited to be part of your life with your little one. The Joie Commuter is a high-quality, fully certified travel cot, approved to AS/NZS 8811.1:2013 and AS/NZS 2195:2010+A2:2015 and Consumer Protection Notice No. 4 of 2008. This product is suitable for children weighing under 15kg (approximately 0-4 years). Please carefully read this manual and follow each step to ensure a comfortable sleeping and best protection for your child.

Please keep the Instruction Manual handy for future reference.

Visit Joiebaby.com to download manuals and see more exciting Joie products. For warranty information, please visit the website at joiebaby.com.

Figures
Warning
Travel Cot Assembly
Fold Travel Cot
Cover Travel Cot
Bassinet Assembly
Changer Assembly
Care and Maintenance
Emergency

Emergency

In case of emergency or accident, it is most important to have your child taken care of with first aid and medical treatment immediately.

Product Information

Read all the instructions in this manual before using this product. If you have any further questions, please consult the retailer. Some features may vary depending on model.

Product: Commuter Travel Cot

Suitable for: Birth to 15kg (approximately 0-48 months)

Product: Changer

Suitable for: Discontinue using changer when child reaches 11kg (approximately 0 - 12 months) or is able to climb out.

Product: Bassinet

Suitable for: Discontinue using bassinet when child can sit, kneel, or roll over or pull itself up (approximately 0-6 months).

Materials: Plastics, metal, fabrics

Patent No.: Patents pending

Made in: China

Brand Name: Joie

Website: joiebaby.com

Parts List

Make sure all parts are available before assembly. Accessories may be sold separately or may not be available depending on region. If any part is missing, please contact local retailer. No tools are required for assembly.

1. Travel Cot
2. Mattress
3. Carry Bag
4. Corner
5. Long Rail
6. Short Rail
7. Zipper
8. Latch Button
9. Foot
10. Folding Webbing
11. Foot
12. Support Tube
13. Bassinet
14. Soft Goods
15. Support Tube (X2)
16. Support Plastic Assembly (X2)

Diagram shows a visual representation of the travel cot with numbered parts corresponding to the list above.

Travel Cot Assembly

Please read all the instructions in this manual before setting up and using this product.

Step 1: Pull the short rails up until both become rigid. If not rigid, pull up again until they are rigid. [Diagram shows a person pulling up the side rails of the travel cot until they click into place.]
[NOTE] If short rails do not latch, raise the base of the floor halfway up, and then pull up again to latch the rails.
Step 2: Latch the long rails. [Diagram shows a person latching the longer side rails.]
Step 3: Push the base of the floor down. [Diagram shows a person pushing the cot's base downwards.]
[NOTE] Be sure all rails have locked before lowering the base.
Step 4: Assemble the support tubes. [Diagram shows how to connect the support tubes.]
Step 5: Install mattress. [Diagram shows the mattress being placed inside the cot.]
Step 6: Pull the strap through the button hole on the bottom of the travel cot. Wrap the strap around the tube and fasten the snaps. Repeat on the other corners. [Diagram shows securing the straps to the cot's frame.]
[NOTE] Push down on all four corners of the mattress to ensure the mattress is secured to the bottom of the travel cot.
Step 7: Install mattress, soft side up. [Diagram shows the mattress correctly positioned with the soft side facing upwards.]
It can be used when the installation mode is correct.

[NOTE] Take care and pay attention when assembling the cot to prevent injury.

Fold Travel Cot

Step 1: Remove the mattress. [Diagram shows the mattress being lifted out of the cot.]
Step 2: Pull the folding webbing upward. [Diagram shows pulling the webbing straps to initiate the folding process.]
[NOTE] Do not unlock rails yet. The base of the floor must be halfway up before the rails will unlock.
Step 3: Unlock all four rails by following these steps:
1. Slightly lift the base of the rails. [Diagram shows lifting the cot's base slightly.]
2. Squeeze the latch button on the rail to release the two tubes. [Diagram shows pressing a latch button on a rail to release it.]
[NOTE] Do not force fold. Both tubes must be released for the rail to fold. If the rail does not fold completely, please lift the base of the floor higher, and then try again from step 3.
Step 4: Fold the unit, but do not force. [Diagrams show the cot being folded.]
[NOTE] If the unit will not fold, look for a partially latched rail. Squeeze the latch button to release the rail.

[NOTE] Take care and pay attention when folding the cot to prevent injury.

Cover Travel Cot

Cover unit with carry bag, and then zip together. [Diagrams show the travel cot being placed into the carry bag and then zipped closed.]

Bassinet Assembly

[TIP] Before setting up the bassinet, make sure all rails have become rigid.

Step 1: Zip up the bassinet and secure the zipper head with a buckle, then cover it with a flap. [Diagram shows zipping the bassinet and securing the zipper with a buckle and flap.]
[NOTE] Must zip up the bassinet completely without crevice before using.
Step 2: Assemble the support tubes. [Diagram shows assembling the support tubes for the bassinet.]
Step 3: Place the mattress into the bassinet. [Diagram shows placing the mattress into the bassinet.]
[NOTE] Place mattress, soft side up.
Step 4: The installed bassinet is shown. [Diagram shows the fully assembled bassinet installed in the cot.]
Step 5: It can be used when the installation mode is correct.
Step 6: Remove support tube as shown. [Diagram shows removing a support tube from the bassinet.]

[NOTE] Take care and pay attention when assembling and removing the bassinet to prevent injury.

Changer Assembly

[NOTE] The changer must be used with the travel cot on compatible Joie models. It can be used when the installation mode is correct.

Diagrams show the process of attaching the changer to the travel cot. This involves connecting frame pieces, securing them with latches, and ensuring a stable fit.

[NOTE] Take care and pay attention when assembling and removing the changer to prevent injury.

Care and Maintenance

The covering material is not removable.
Your travel cot can be spot cleaned with a sponge and soapy water.
Do not use undiluted neutral detergent, gasoline, or other organic solvents to wash the travel cot, as it may cause damage.
To wash the carry bag, machine wash in lukewarm water and drip-dry. Do not use bleach.
When at the beach or in the garden, clean sand and grit off your travel cot. Sand in the long rail locks may cause damage.
From time to time, check your travel cot for worn parts, torn material, or stitching. Replace or repair parts as needed.
If the travel cot is not in use for a long period of time, please store it in the shade where your child cannot access it.

	Joie Excursion Travel Cot: Assembly, Safety & Care Guide Official instruction manual for the Joie Excursion Travel Cot. Learn how to safely assemble, fold, and maintain your travel cot for children up to 15kg. Includes parts list, safety warnings, and care instructions.
	Joie allura™ Travel Cot Instruction Manual Comprehensive instruction manual for the Joie allura™ travel cot, covering assembly, setup, folding, covering, care, and safety warnings. Suitable for children up to 15kg (approximately 0-4 years).
	Joie Kubbie Travel Cot Instruction Manual Comprehensive instruction manual for the Joie Kubbie Travel Cot, detailing assembly, folding, care, and safety guidelines for safe and comfortable use for children up to 15kg.
	Joie Kubbie Sleep Travel Cot Instruction Manual Comprehensive instruction manual for the Joie Kubbie Sleep Travel Cot, covering assembly, folding, safety warnings, and care instructions.
	Joie Cheer™ Playpen: Assembly, Safety & Care Instructions Comprehensive instruction manual for the Joie Cheer™ playpen. Learn how to assemble, fold, use, and care for your high-quality, certified playpen. Includes safety warnings and usage guidelines for children up to 15kg.
	Joie Ramble Carry Cot User Manual and Safety Guide Comprehensive instructions and safety guidelines for the Joie Ramble Carry Cot, covering assembly, usage, and maintenance for parents and caregivers.
	Joie Ramble XL Carry Cot: User Manual, Safety, and Assembly Guide Explore the Joie Ramble XL Carry Cot with this official user manual. Find detailed instructions on assembly, safe usage, care, and maintenance, ensuring optimal comfort and security for your baby. Compliant with EN 1466:2014/AC:2015.
	Joie Ramble Carry Cot User Manual and Instructions Comprehensive guide for the Joie Ramble Carry Cot, covering assembly, usage, safety warnings, and care instructions. Learn how to safely attach, use, and maintain your Joie Ramble Carry Cot for infant transport.