Manual: Setup and Inflation
Important Safety Note: DO NOT use the pump continuously for more than 5 minutes to prevent overheating. ⚠️
Take the GIGA Sofa out from the storage bag, lay it out and close the valve. (Diagram: Sofa being removed from a bag, laid flat, valve closed).
Open the seal cap of the air pump. (Diagram: Hand opening a cap on the air pump).
Unplug the air inlet stopper. (Diagram: Hand unplugging the stopper from the sofa's inflation port).
Press the power button to start inflating. (Diagram: Hand pressing the power button on the pump).
Insert the air inlet stopper tightly once fully inflated. (Diagram: Hand inserting the stopper into the fully inflated sofa's port).
Turn off the power switch. (Diagram: Hand turning off the pump switch).
Tighten the seal cap. Start using the GIGA Sofa. (Diagram: Hand tightening the cap on the sofa's port, followed by an image of the inflated sofa).
Storage Process
Open the exhaust outlet valve at the GIGA Sofa back completely. Completely deflate the GIGA Sofa until it goes fully flat. Then roll the end up, fold it together and put it back into the storage bag. (Diagrams: Valve opened, sofa deflating, sofa rolled, sofa folded, sofa placed in bag).
Repair Process
Note: Remove the cover of the GIGA Sofa and take out the inner liner before patching. If you encounter any difficulties, please contact customer service or login to check the official website. ?
Locate the hole and clean the surface of the area around the leak. (Diagram: Hand cleaning a spot on the sofa).
Take off the patch. (Diagram: Hand peeling a patch from its backing).
Patch the hole. (Diagram: Hand pressing the patch onto the sofa).
Safety and Care
About Battery
Do not attempt to replace the battery yourself or by untrained technicians. Improper replacement and repair procedures could cause overheating, or result in injury. If you suspect a swollen or damaged battery, please contact the manufacturer or authorized dealer.
Disposal instructions for batteries: To discard the battery of this device, please Do NOT dispose with regular household garbage, but drop off at the nearby waste battery recycling station for centralized treatment. ♻️
Reminder
- Due to the stretchy upholstery fabric, the GIGA Sofa will naturally turn soft after using over a period of time. This is a normal phenomenon. Simply switch on the air pump and reinflate it again.
- If you carelessly puncture the GIGA Sofa, first take off the sofa fabric cover then patch the punctured hole with the patch provided.
- Make sure the exhausted air valve is tightly closed to avoid air leakage while inflating.
- Handle the air pump with care while folding and packing the GIGA Sofa to avoid damages caused by collision.
Warning
- Children under 12 must be assisted by parent or guardian when using the product.
- Do not allow any liquid to touch battery terminals.
- Do not put your fingers in the inflation port while inflating.
- Keep the air inlets and charging ports clean.
Specifications and Compliance
Basic Information
Brand: Aerogogo
Model: BS2-01
Manufacturer: Shanghai Micronovelty Co., Ltd.
Manufacturer Address: Room 403, Unit 2, Lane 88, Shengrong Road, China(Shanghai) Pilot Free Trade Zone
Service Email: service@aerogogo.com
Official Website: www.aerogogo.com
Made in: China
For after-sale support, please contact your authorized Aerogogo retailers or official customer support for more information.
Product Details
- Weight: 4.10 kg
- Folded size: 35 cm * 35 cm * 15 cm
- Inflated size: 103 cm * 80 cm * 74 cm
- Air pump power: 33.6 W
- Charging time: 6 hours
- Battery capacity: 3.7 V 3800 mAh
- Input: 5 V ⎓ 1A
- Usage times of one full charge: 10 times
- Material of the removable fabric cover: Polyester
- Material of the inner liner: PVC
- Material of air pump: ABS + Silicone + PVC
Package Contents
- Storage Bag * 1
- GIGA Sofa * 1
- Patches * 2
- Charging Cable * 1
Regulatory Compliance Information
WEEE (Waste Electrical and Electronic Equipment): All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points. ?
EU Declaration of Conformity: We, Shanghai Micronovelty Co., Ltd. hereby, declare that this equipment is in compliance with the applicable directives and European Norms, and amendments. (CE Mark)
Other Compliance Marks: ROHS, REACH, EAC
