Sunwaytek SG-N10W Wireless Controller for Nintendo Switch

Diagram

Illustration of the Sunwaytek SG-N10W wireless controller. It features a D-pad, analog sticks, ABXY buttons, shoulder buttons (LT, LB, RT, RB), Home button (?), Capture button (?), and a USB-C port. A Bluetooth range indicator shows "26ft WORKING DISTANCE".

Update Mode: (Software required) Hold down the designated button, then connect to PC.

Home Button Functions:

• Off Status: Hold down for sync (refer to Pairing & Link guides).
• During Playing: Press to return to the HOME screen; Hold down to activate Sleep Mode option.

Charging: Connect to a Switch dock or wall adapter via the USB-C port (?).

Wired Play on PC: Connect via USB. ABXY buttons auto-shift to Xbox layout. ⚠️ Mind the USB plug side! Refer to the printing mark.

Compatibility: Indicated by icons for [Nintendo Switch logo] and [Windows logo].

Capture Button: Press to capture a screenshot (?).

Sleep Button: Press to disconnect from the console and force the controller into sleep mode (?).

Calibrate Motion Sensor (when unlinked): Lay the controller on a level table. Hold down the − and B buttons, then press the Home button (?). LED lights will start blinking. Press the + button, then wait until the lights turn off. This calibration is recommended only if motion control feels imprecise.

Pairing

You only need to perform pairing once when you have a new controller or after a firmware update. Follow the steps below:

Illustration of the Nintendo Switch HOME screen menu for pairing controllers. It shows options like "Controllers" and "Change Grip/Order". The screen displays four numbered slots (1, 2, 3, 4) for controllers.

1. From the Nintendo Switch HOME screen, select "Controllers", then "Change Grip/Order". Stay on this pairing screen. (Operate using a Joy-Con, touch, or a paired controller. ⚠️ Ignore the instruction of the last screen.)
2. On the SG-N10W controller, hold down the Home button (?) and the Y button simultaneously.
3. Release the buttons when the LED light on the controller starts twinkling. Wait for approximately 10 seconds.
4. The LED stops twinkling, and one or more lights turn on (✔️), indicating successful pairing.

Press the A button when you are ready.

Link (Reconnect)

If the controller has been paired before, follow these steps to turn it on and reconnect to the console:

Illustrations showing the controller buttons and LED indicator during the linking process.

1. Press the Home button (?) on the controller.
2. Release the button when the LED light starts twinkling. Wait for approximately 5 seconds.
3. The LED stops twinkling, and one or more lights turn on (✔️), indicating a successful reconnection.