Bestway Flowclear™ Filter Pump Owner's Manual

Important Safety Instructions

WARNING-RISK OF ELECTRIC SHOCK

• The pump must be supplied by an isolating transformer or through a residual current device (RCD) with a rated residual operating current not exceeding 30 mA.
• The appliance must be supplied by an earthed power source.
• Extension cords cannot be used.
• The pump cannot be used while people are inside the pool.

DO NOT BURY CORD. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and other equipment.

WARNING- The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped.

CAUTION- This pump is for use with storable pools only. Do not use with permanently-installed pools.

IMPORTANT - Using the pump with an unmatched electrical supply is dangerous and will result in catastrophic failure of the pump.

RISK OF ELECTRICAL SHOCK- When working with electricity, turn the electrical power off at the circuit breaker and lock the breaker door. Failure to do so will result in increased risk of shock, injury, and possibly death.

DO NOT REMOVE THE GROUNDING PRONG OR MODIFY THE PLUG IN ANY WAY. DO NOT USE ADAPTOR PLUGS. Consult a qualified electrician for any questions related to the validity of your plugs grounding.

Handle the pump with care. Do not pull or carry the pump by the power cord. Never pull a plug from the outlet by yanking the power cord. Keep cord free from abrasions. Sharp objects, oil, moving parts, and heat should never be exposed to the filter pump.

WARNING- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with this product.

CAUTION: Read the instruction before using the appliance and installation/reassemble each time.

Cleaning and user maintenance must be performed by an adult above 18 years old who is familiar with the risk of electric shock.

NOTE: Please examine equipment before use. Notify Bestway at the customer service address listed on this manual for any manufacturing defect or missing parts at the time of purchase. Verify that the equipment components represent the filter pump model that you had intended to purchase.

NOTE: Place pump on a solid and level ground. Pay attention to position of pool and pump so adequate ventilation, drainage, and access for cleaning is available. Never place pump in an area that may accumulate water, or in an area where foot traffic will flow around the pool. It is necessary to have the plug accessible after installation of the pool.

NOTE: Atmospheric conditions may affect the performance and life span of your filter pump. Unnecessary wear and tear may occur during periods of cold, heat and exposure to sun. Whenever possible shelter pump from these conditions.

It is important to ensure the factory equipped stopper plugs for the inlet and outlet ports replace the screens before removal or maintenance on the pump is attempted.

NOTE: Do not add chemicals in the filter pump.

Don't plug or unplug the appliance if hand is wet. Always unplug the appliance:

• On raining days
• Before cleaning or other maintenance
• Leave it unattended on holidays

When the appliance will not be used for long time, such as in the winter, the pool set should be disassembled and stored indoor. Safekeeping the instruction. For reconstruction the pool set every time, please always refer to the instructions.

If instruction is missed, please contact Bestway or search it on the website: www.bestwaycorp.com

NOTE: This product is not intended for commercial use.

SAVE THESE INSTRUCTIONS.

Parts List and Diagrams

The following diagram illustrates the components of the filter pump:

Component Identification:

• P6112: Air Purge Valve
• P6113
• P6114 / P6(H1)114
• P6116
• P6118
• 58093
• P6719AU
• P6019
• P6132
• P6124
• P6362
• P6680
• P61318

Parts Quantity Table:

Assembly Steps:

1. Connect the pump to the pool's inlet and outlet hoses using the provided clamps. Ensure the Air Purge Valve (P6112) is open.
2. Fill the pool with water. As water fills the pump, open the Air Purge Valve (P6112) to release air.
3. Once water flows from the Air Purge Valve, close it and wipe away any excess water.
4. Insert the plug into a residual current device (RCD) to start the pump.
5. IMPORTANT: DO NOT DRY RUN THE FILTER PUMP. Ensure both the pool's Inlet and Outlet valves are fully covered by water before operating the pump.

Operation

1) Open/unscrew the Air Purge Valve (P6112) on the top of the Filter Pump; air is released as water fills the Filter Pump.

2) When water comes out of the Air Purge Valve (P6112) screw it closed and wipe away any water.

3) To start the Filter Pump, insert the plug into a residual current device (RCD).

IMPORTANT: DO NOT DRY RUN THE FILTER PUMP - Make sure both the pool's Inlet and Outlet valves are fully covered by water before operating the Filter Pump.

Maintenance

CAUTION: YOU MUST ENSURE THE FILTER PUMP IS UNPLUGGED BEFORE ANY MAINTENANCE OR STORAGE BEGINS OR SEVERE RISK OF INJURY OR DEATH EXISTS.

1. Unplug the Filter Pump.
2. Loosen the Hose Clamps on the pool's Inlet and Outlet Hoses by unscrewing the fly nut counter-clockwise.
3. Remove Debris Screens from inside of pool.
4. Replace the Debris Screens with the Stopper Plugs in the pool's Inlet and Outlet Valves.
5. Unscrew the Filter Cap Retainer and remove the Filter Cap.
6. Clean the Filter Cartridge with a garden hose. If the filter cartridge remains soiled or discolored, it is necessary to replace it with a new one.
7. Insert the cleaned (or new) Filter Cartridge; ensure it is centered in the Filter Pump.
8. Check that the Filter Cap Seal is in place.
9. Replace the Filter Cap and screw the Filter Cap Retainer into position.
10. Replace the Stopper Plugs with the Debris Screens in the pool's Inlet and Outlet Valves. Tighten the Hose Clamps. Water will now flow to the pump.
11. Follow PUMP INSTALLATION DIRECTIONS section to prepare the system for use.

IMPORTANT: For sanitary reasons, it is suggested to replace the Filter Cartridge with a new one every two weeks.

Storage

1. Unplug the Filter Pump.
2. Follow the instructions as previously outlined to stop water flowing to the Filter Pump and to remove the Filter Cartridge.
3. Discard the Filter Cartridge.
4. Detach all Hoses.
5. Dry all components thoroughly.
6. Store the filter pump in a dry location out of child's reach. Storage temperature: 4-40°C (39.2-104°F).

Pump Warranty

For information concerning pump warranty, please visit our website at: www.bestwaycorp.com

Limited BESTWAY® Manufacturer's Warranty

The product purchased comes with a limited warranty. Bestway® assures the product will be free from manufacturer's defects.

To enact a warranty claim, this form must be completed and submitted with a copy of your purchase receipt to your local Bestway After Sales Center. Please contact your local Bestway After Sales Center before sending any documents. Bestway® will not replace any products deemed to be damaged due to negligence or having been used outside of the owner's manual guidelines.

Bestway's warranty covers manufacturing defects discovered while unpacking the product or during use as recommended within the user manual. This warranty applies only to products which have not been modified by any 3rd parties. The product must be stored and handled in accordance with the technical recommendations.

The warranty does not cover damages caused by misuse, abuse, neglect, including, but not limited to collision, fire, use of incorrect voltage, excessive heat exposure, improper installation, improper wiring or testing, or improper storage.

Replacements and repairs do not extend the duration of the warranty. The warranty start date is the date of sale shown on the original receipt/purchase invoice.

Required Information - Please Write the Delivery Address:

• Name:
• Address:
• Zip Code:
• Country:
• City:
• Retailer:
• Mobile:
• Telephone:
• Fax:
• E-mail:

Please Clearly Write Your Item Code:

Problem description:

• Water leakage
• Stopped working
• Missing part - Please use the code for the missing part. This can be found in the owner's manual.
• Other (Please describe)

IMPORTANT: ONLY THE DAMAGED PART WILL BE REPLACED, NOT THE COMPLETE SET.

Bestway reserves the right to request photographic evidence of defective parts, or to require sending the item for additional testing. In order to best assist you, we request all information you provide to be complete.

For FAQ, Manuals, Videos or Spare Parts, please visit our website: www.bestwaycorp.com

Videos are also available on our Bestway channel on YouTube: www.youtube.com/user/BestwayService