WIRELESS TRANSMITTER

PRODUCT WARNING ⚠️

READ AND SAVE THESE INSTRUCTIONS.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

This product is not intended for users by persons (including children) with reduced physical, sensory, or mental capabilities, or lack experience with and knowledge, unless they have been given supervision or instruction concerning use of appliance by a person responsible for their safety.

• This product contains small parts and is not safe for consumption. Keep out of reach of children and pets. If ingested, seek immediate medical assistance.
• This product must not be used or placed in potentially hazardous locations such as flammable, explosive, electrical, chemical-laden, or wet atmospheres.
• Do not place walls or large obstacles between the transmitter and the receiver. This may cause signal interference.
• To ensure an uninterrupted signal, place the transmitter and receiver within the following distances based on how many transmitters are connected to your controller:
  • 1 TRANSMITTER: ≤ 26 ft
  • 2 TRANSMITTERS: ≤ 16 ft
  • 3-8 TRANSMITTERS: ≤ 10 ft.

PRODUCT CONTENTS

• TRANSMITTER (x2): Two units depicted, each resembling a small black cylinder with a cable extending from one end, terminating in a connector.
• RECEIVER (x2): Two units depicted, similar in appearance to the transmitters, small black cylinders with cables and connectors.
• ADAPTER (x2): Two units depicted, appearing as simple cylindrical connector pieces.

This product is only compatible with specific devices and controllers. Visit the website at www.acinfinity.com for a complete list of compatible products.

CONNECTING TO YOUR CONTROLLER

Step 1: Matching Codes

Illustration shows a transmitter unit with a cable and connector, and a receiver unit with a cable and connector. Text emphasizes matching codes.

Step 2: Direct Connection

Diagram shows a controller unit and a target device. A transmitter is connected to a port on the controller. A receiver is connected to a port on the device. A line indicates a maximum distance of "<26 ft." between them. The text explains: "Plug the transmitter into one of your controller's ports and the receiver into your device."

Step 3: Using the Adapter

Diagram illustrates connecting a receiver to a device. The device has a male connector. The receiver has a female connector. A female-to-female adapter is used to bridge the connection. The text explains: "If your device has a male connector, use a female-to-female adapter to connect the receiver to your device."

MORE INFORMATION

WARRANTY & CONTACT

WEBSITE: www.acinfinity.com

EMAIL: support@acinfinity.com

PHONE: 626-923-6399

HOURS: 9 am to 5 pm PST

ADDRESS: 21880 BAKER PARKWAY, CITY OF INDUSTRY, CA 91789

DEALERS

EMAIL: dealers@acinfinity.com

PHONE: 626-838-4656

HOURS: 9 am to 5 pm PST

MANUAL CODE: WTA2412X1

COPYRIGHT © 2025 AC INFINITY INC. ALL RIGHTS RESERVED

No part of the materials including graphics or logos available in this booklet may be copied, photocopied, reproduced, translated or reduced to any electronic medium or machine readable form, in whole or in part, without specific permission from AC Infinity Inc.