REVOLT™™ CAN CRUISERS CARS User Manual

Important Safety Information

Thank you for purchasing a REVOLT product. To ensure the proper operation of your vehicle, please read the following information carefully. Before using the product for the first time, please read the instruction manual thoroughly and store it in a safe place for future reference.

Safety Information:

• Keep small parts out of reach of children.
• Do not store the battery in high-temperature environments (e.g., near open flames or heating devices).
• Children must be supervised by an adult while operating the vehicle. The vehicle should always remain within the sight of the driver (or instructor).
• Do not charge non-rechargeable batteries. When installing or replacing batteries, ensure the correct polarity is connected. Do not mix old and new batteries or different types of batteries.
• Do not short-circuit the battery terminals.
• If you do not plan to use the vehicle for an extended period, remove the batteries from both the vehicle and the remote control to prevent corrosion of the circuits.
• After use, ensure the vehicle and remote control are turned off, and remove the batteries from the remote control.
• The packaging and this manual contain important information and should be stored in a safe place for future reference.

Maintenance and Care:

• Regularly clean the product with a clean, soft cloth.
• Avoid exposing the product to direct sunlight or high temperatures.
• Do not submerge the product in water, as this may damage the electrical components.

Operating Instructions

Opening the canister and separating the Car from the Remote Control

To open the canister, press the [power button symbol] button on the top of the lid and remove the lid. Then, slide the remote control off the car in the direction of the arrow [slide direction arrow].

The product features: GLOW LIGHT EFFECT, REVOLT, EASY TO CONTROL, FULL FUNCTION, ANTI SLIP.

Driving Operation Instructions

Use the remote control for the following operations:

• Forward: Push the control stick forward.
• Backward: Pull the control stick backward.
• Left: Push the control stick left.
• Right: Push the control stick right.

Steering Fine Tuning

Use the steering trim dial on the remote control to adjust the car's direction if it pulls to one side while moving forward.

Battery Requirements

For the Vehicle (Car):

Requires 2 x 1.5V "AAA" batteries (not included).

1. First, unscrew the screw [screw] using a screwdriver.
2. Press and slide the battery cover down to open it.
3. Install 2 x 1.5V "AAA" batteries into the battery compartment, observing the correct polarity (+ and - terminals) for the batteries as illustrated inside the compartment.

For the Remote Control:

Requires 2 x 1.5V "AAA" batteries (not included).

1. Locate the battery compartment on the remote control.
2. Remove the battery cover (usually by sliding or unlatching it).
3. Install 2 x 1.5V "AAA" batteries, ensuring correct polarity (+ and - terminals match the markings in the compartment).
4. Replace the battery cover.

Pairing Instructions

Follow these steps to pair the remote control with the car:

1. Turn on the bottom switch of the car to "ON".
2. Press and hold the [pairing button] switch on the remote control.
3. Wait for 1-2 seconds. The remote control and car will automatically pair.

Specifications

CONTENTS:

• Remote Control Car
• Remote Control
• Canister for Storage
• Instruction Manual

FCC Compliance Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement: This device complies with FCC radiation exposure limits set forth for general population (uncontrolled exposure). This device must not be connected or operating in conjunction with any other antenna or transmitter.

The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.

Manufacturer Information

Manufacturer: SYMA MODEL AIRCRAFT INDUSTRIAL CO.LTD

Address: Intersection of Xingye Road No. 2 (West side) and Xingye Road (North side), Laimei Industrial Park, Chenghai District, Shantou, Guangdong Province, China

Sales hotline: 0754-86980668

After-sales hotline: 0754-86395095

Fax: 0754-86395098

Zip code: 515800

The manufacturer reserves the right to the final interpretation of this instruction manual.