TRÅDFRI 10W LED Driver

Getting Started

If you have the TRÅDFRI gateway or DIRIGERA hub, download the IKEA Home smart app from the App Store or Google Play. The app will guide you through installing your product and other devices.

How to Steer Your Lighting

When the product is connected to the mains, it can be turned ON/OFF with the main switch or foot switch. For dimming or connecting to other IKEA Home smart products, a separate steering device (e.g., a remote control) is required.

The steering device must be paired with your wireless product. You can pair multiple products with one steering device for simultaneous control.

Pairing a Steering Device to Your Product

1. Connect at least one (1) product to the mains power before pairing. Ensure the mains power is ON.
2. Locate the pairing symbol on the LED driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
3. Press and hold the pairing button on the steering device for at least 10 seconds. A steady red LED light will appear on the steering device. The product will dim and flash once to indicate successful pairing.

How to Factory Reset Your Driver

If the product does not respond or you wish to un-pair it from a steering device, a factory reset may be necessary. To perform a factory reset, carefully push and hold the small button (marked RESET) on the LED driver enclosure with a pen tip.

Important Information

• The product is for indoor use only and can be used in temperatures ranging from 5°C to 45°C.
• Do not expose the product to direct sunlight or near any heat source to prevent overheating.
• The declared radio range is measured in open air.
• Building materials and unit placement can affect wireless connectivity range.

Care Instructions

Clean the unit with a dry, soft cloth. Do not use abrasive cleaners or chemical solvents, as they can damage the product.

Product Servicing

Do not attempt to repair this product yourself. Opening or removing covers may expose you to dangerous voltage points or other risks.

Save these instructions for future use.

Technical Data

Type: ICPSHC24-10EU-IL-2

Input: 220-240 VAC, 50/60 Hz, 0.1 A

Output: 24.0 VDC

Max total load: 0.42 A, 10.0 W

Radio range: 10 m in open air.

Operating frequency: 2400-2483.5 MHz

Output power: 12 dBm

Dimension, mm: 186x55x18.5 mm

Weight: 114 gr

Type of light source(s): LED

Efficiency in full-load: 85 %

No-load power consumption (Pno): 0.18 W

Networked standby power consumption (Pnet): 0.18 W

Standby power consumption (Psb): N/A

Suitable as dimmer for light sources: Yes

Usage: Indoor use only

Manufacturer

IKEA of Sweden AB

(commercial registration number: 556074-7551)

Address: Box 702, SE-343 81 Älmhult, SWEDEN

Disposal

The crossed-out wheeled bin symbol [?️] indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.