Outsunny 845-584V00 Planter with Trellis Assembly Guide
Model Number: 845-584V00
Estimated Assembly Time: 1 Hour
Total Steps: 9
Important Information
Please read these instructions carefully before assembly and retain them for future reference.
Parts List
- Part A: Two horizontal slats with two vertical supports (x1)
- Part B: Three horizontal slats with two vertical supports (x1)
- Part C: Three horizontal slats with two vertical supports (x1)
- Part D: Small rectangular connector piece with holes (x4)
- Part E: Rectangular base panel (x1)
- Part F: Rectangular panel with slots (x1)
- Part G: Rectangular panels with slots (x2)
- Part H: Rectangular panel with holes (x1)
Hardware List
- Hardware J: Circular clamp with screw hole (x2)
- Hardware K: Circular clamp with screw hole (x2)
- Hardware L: Screw M6x40 (x8 + 1 spare)
- Hardware M: Screw M3x12 (x16 + 1 spare)
- Hardware N: Screw M6x40 (x4)
- Hardware P: Bolt M6 (x4)
- Hardware Q: Screw M6x30 (x16 + 1 spare)
- Hardware R: Top decorative piece (x1)
- Hardware S: Screw M4 (x10)
- Hardware T: Allen key (x1)
- Hardware U: Screw M4 (x1)
Note: Do not confuse similar screws.
Assembly Steps
Step 1
Attach the two Part G panels vertically to the sides of the Part F panel. Secure each connection using four (4) Part L screws.
Step 2
Attach the Part H panel horizontally to the bottom of the structure formed in Step 1, connecting the two Part G panels. Secure using four (4) Part L screws.
Step 3
Attach the Part E panel horizontally on top of the Part H panel, connecting the two Part G panels. Secure using four (4) Part L screws.
Step 4
Attach the two Part K clamps to the outer sides of the Part F panel. Secure each clamp using two (2) Part M screws.
Step 5
Attach the Part A panel to the top of the Part F panel, between the Part G panels. Secure using two (2) Part N screws and two (2) Part P bolts.
Step 6
Attach the Part B panel to the Part A panel. Secure using four (4) Part D connectors and four (4) Part Q screws.
Step 7
Attach the Part C panel to the Part B panel. Secure using four (4) Part D connectors and four (4) Part Q screws.
Step 8
Place the Part R decorative piece on the very top of the assembled structure.
Step 9
Secure the entire structure by fastening ten (10) Part S screws into the designated points.
