iTouchless AV002A Intelligent Cleaner

Register Today to Protect Your Product

www.iTouchless.com/register

Introduction

Dear customers, Thank you for using our Intelligent Vacuum Cleaner!

The Intelligent Vacuum Cleaner is a product of iTouchless, manufactured using advanced mechanical and electronic technology. It is designed for versatile use in homes, offices, and entertainment areas, capable of cleaning hard-to-access spaces. This intelligent cleaner aims to enhance your quality of life.

It is recommended for indoor use on floor surfaces including hardwood, linoleum, tile, and low-pile carpets. For enhanced shine on hardwood or tile floors, clean the brush after use, apply liquid wax with the included spoon, and run the cleaner again. Its fashionable flat design allows it to reach under furniture like sofas and beds. The integrated remote control function enables hands-free operation.

Package Contents

When you unpack the box, the Intelligent Cleaner will be included with the following attachments:

• Battery Charger x 1
• Rechargeable Battery Pack (Installed) x 1
• Spoon x 1
• Filter Mesh x 1
• Remote Controller x 1
• Side Brush x 1
• Dust Brush x 1
• Operating Manual x 1

Product Overview

Surface View

Bottom View

Operating Procedures

1. Ensure the battery is fully charged before starting the Cleaner.
2. Tidy unfixed articles on the floor before use. Keep the cleaner away from carpet edges and power lines.
3. Turn on the main power start button. There are three start buttons: Spot, Clean, and Max, representing different cleaning modes.
   1. Spot mode (I): Cleans a 3-foot diameter area for 4 minutes, focusing on dirt in partial places.
   2. Clean mode (II): Automatically cleans the room for 30 minutes, suitable for small rooms.
   3. Max mode (III): Runs until the battery is drained, with a maximum working time of 60 minutes.
4. If the wrong start button is pressed, press other start switches twice to switch to the correct mode.
5. The maximum working time is approximately 45-60 minutes, sufficient for a normal-sized room. The battery life indicator turns red when power is low, and the unit stops working. Recharge when this occurs.

Note on Charging

• a. Voltage Confirmation: Firstly, confirm that the charging voltage matches the local standard to prevent unit damage.
• b. Charging Indicator: The power indicator on the panel flashes during charging and turns solid green when fully charged. Charging stops automatically to protect the charger. Charging time is typically 4-5 hours.
• c. Storage: Store the charger in a dry, well-ventilated area. Do not use in wet environments like bathrooms.
• d. Handling: Mistreating the charger (e.g., pulling by the cable) can damage the unit and pose an electrical hazard.
• e. Battery Life: For extended battery life, initially charge for 8-9 hours. After a long period of disuse, recharge before use. Optimal performance is achieved after 2-3 charge/discharge cycles.

Remote Controller Operation

The cleaner is controlled via the infrared remote. The mode keys (Spot, Clean, Max) activate respective working modes. Directional keys control movement. The 'P' key powers the unit on/off. Pressing 'P' turns off the unit indicator and enters Sleep mode (energy saving). Pressing 'P' again turns the indicator on and enters Standby mode.

The Intelligent Cleaner requires minimal maintenance. For optimal performance, observe the following procedures:

Maintenance

Emptying the Bin

1. Turn off the power switch.
2. Press the bin clip and pull out the bin.
3. Clear the bin.
4. Press the clip on the bin to reinsert it back into the unit.

Cleaning the Filter Mesh

1. Turn the bin upside down.
2. Press the bottom slightly and take the filter mesh out.

Illustration showing how to remove the filter mesh from the bin.

3. Clear the dirt on the filter mesh.
4. Fit the filter mesh back to the bin.

Press the clip slightly and put the bin back to the Cleaner.

Cleaning the Main Brushes

1. Turn off the power switch and place the Cleaner on a flat surface with its bottom side up.
2. Use a Phillips head screwdriver to remove the fixing screw on the right. Take out the main brush, rubber brush, and brush coupler.

Illustrations showing the bottom of the cleaner and the removal of the main brush assembly.

3. Clean the brush chamber and remove debris from the brushes.
4. Wipe dirt from the metal shaft and bearing of the brush coupler and brushes. A little lubricant may be added if necessary.

Illustrations showing cleaning the brush components.

5. Reassemble the brush coupler and brushes, then tighten the screw.

Cleaning the Vacuum Inlet Lid

1. Turn off the power switch and turn the Cleaner upside down on a flat surface.
2. Take out the Vacuum Inlet Lid as per the illustration.

Illustration showing the removal of the vacuum inlet lid.

3. Clean the Vacuum Inlet Lid and the fan-shaped mechanism to ensure good ventilation.
4. Carefully guide the hinge tabs on the Vacuum Inlet Lid back into their holes.

Method for Replacement of Side Brush

The side brush is replaceable.

1. Remove the two screws as per Fig. 1.
2. Turn the side brush to allow screwdriver access as per Fig. 2. Loosen the screw, remove the old brush, and replace it with a new one.
3. Install the side brush and bottom housing in reverse order.

Intelligent Path Judgment

The cleaner is intelligently controlled to avoid obstructions and prevent falls from edges like tables or stairs.

⚠️ Caution: Please remove small objects such as vases or paper boxes that could be knocked down during operation. Clear these items before starting the cleaning cycle.

The Intelligent Cleaner is a vacuum cleaning device that controls dust, serving as a wonderful cleaning assistant. Attention should be paid to the following points:

1. If the unit stops after a short sound, the battery may be low or off, requiring charging.
2. Do not use the Cleaner on medium and high-pile carpets.
3. Avoid using the Cleaner near objects like clothing, power cords, or towels, as these can entangle the brushes.
4. Turn off the power when not in use. Ensure the unit is fully charged if it has not been used for a long period. Remove the battery and store both the unit and battery in a cool place when not in use. Keep the bottom of the cleaner dry and clean.

Troubleshooting

1. Cleaner dropped from edge of stairs: Solution: Wipe away dust from the probe at the bottom of the front plate with a dry cloth.
2. Cleaner and light turn on, but no movement:
   • Make sure there are no obstacles in the pathway.
   • Check if carpet height is less than 1 inch.
   • Clean debris from brushes.
   • Clean out the trash compartment.
   • Clean sensors with a damp and dry cloth.
   • Try all 3 modes.
   • Charge overnight.
3. Runs for a few minutes, then turns off:
   • Check for any obstacles in the way.
   • Try to run mode 3.
   • Charge overnight.
4. No light, no response:
   • Check if the unit is flashing green while charging.
   • Charge overnight.
5. Cannot charge battery:
   • Make sure the battery is installed correctly.
   • Check the connection.
6. Will not run from one surface to another:
   • Check if carpet height is under 1 inch.
   • Make sure there are no obstacles in the pathway.
   • Remove the side brush and try again.
7. Cleaner stays in one place and rotates:
   • Make sure there are no obstacles in the pathway.
   • Clean off brushes.

Caution of Usage

Replacement of Battery

Model of battery: YX-Ni-CD-015144

Battery replacement of the Cleaner:

1. Press the edges of the battery bucket and take out the battery vertically. (Refer to Figure 1 and Figure 2)
2. Ensure correct placement of positive and negative electrodes to prevent damage.
3. Set the Cleaner in charging state to maintain battery health when unused.

Battery replacement of the Space Isolator:

1. Release the screw with a screwdriver and open the base plate. (Refer to Figure 1)
2. Ensure correct placement of positive and negative electrodes to prevent damage. (Refer to Figure 2)
3. Correct battery placement. (Refer to Figure 3)
4. Remove the battery if the unit is unused for a long time.

Battery replacement of the Remote Control:

1. Open the battery cover and replace the battery. (Refer to Figure 1)
2. Ensure correct placement of positive and negative electrodes to prevent damage. (Refer to Figure 2)
3. Remove the battery if the unit is unused for a long time.

Important Battery Disposal Notes:

1. Do not forget to remove the battery before discarding the Cleaner.
2. Turn off the switch before removing the battery from the Cleaner and space isolator.
3. Do not place the battery in high temperatures (above 45°C) or water.
4. Do not exert external force or drop batteries from a height.
5. Batteries should be recycled responsibly. Do not discard them freely or throw them into fire due to explosion risk.
6. If battery leakage occurs, avoid contact with skin or clothes. Clean with a dry mop if touched and send the battery to a recycling bin or maintenance service. Do not dispose of elsewhere.

Safety Precautions

⚠️ Caution:

• Only designated maintenance technicians should disassemble or repair the product to avoid fire, electric hazards, or personal injury.
• Do not touch high-voltage power cords with wet hands to prevent electric shock.
• Do not twist clothes or body parts (head, finger, etc.) into the brush or wheel of the Cleaner, as this may cause personal injury.

⚠️ Caution:

• Use only the included charger. Using a different charger may damage the product or cause electric/fire hazards due to voltage differences.
• Do not bend the power cord excessively or place weight on it, as this can cause cord damage, fire, or electric shock.
• Keep the cleaner away from cigarettes, lighters, matches, and other heat sources or combustible materials.

? Attention:

• Ensure the charger and socket are connected well to prevent charging failure or fire.
• Insert the power cord of the charger fully into the socket to avoid electric shock, short circuits, smoking, or fire.
• Turn off the power when transporting or storing the Cleaner for extended periods to prevent battery damage.
• Remove easily damaged objects (e.g., luminous items, fabrics, glass bottles) before use to prevent damage to these objects or interference with the Cleaner's operation.
• Use the Cleaner cautiously around children to avoid frightening or harming them.
• Do not stand or sit on the Cleaner, as this may cause damage or personal injury.
• Do not allow the Cleaner to ingest water or other liquids to prevent product damage.
• Do not use the Cleaner on small tables, chairs, or in other confined spaces, as this may damage the unit.
• Do not use the Cleaner outdoors, as this may damage the product.
• Do not use the Cleaner in commercial settings, as excessive use may damage it.
• Do not leave movable threads, wires, or other objects longer than 150mm on the ground, as they may entangle the brushes.
• This Cleaner is not intended for use by individuals with physical or mental handicaps, children, or those who have not read the User Manual carefully.

Warranty Information

Any Problem? DO NOT RETURN TO STORE. Contact us at www.iTouchless.com/contacts/ or call toll-free 1-844-660-7978.

ONE (1) YEAR LIMITED WARRANTY

The iTouchless Intelligent Robotic Vacuum Cleaner PRO (Cleaner) is distributed by iTouchless Housewares & Products, Inc. (iTouchless). It is warranted to be free from defects in material and workmanship for 365 days from the date of original purchase within the United States and Canada, provided normal use and care, and with proof of purchase. iTouchless honors warranty requests only from orders placed with authorized dealers. Items sold as used, floor samples, or refinished are subject to the selling party's terms, and iTouchless will not warrant such purchases. iTouchless will repair or replace a defective Cleaner during the warranty period.

Warranty Exclusions: The customer's exclusive remedy for product defects does not apply to:

• User modifications.
• Attachments to the product by the user that cause damage.
• Products with broken, removed, tampered with, defaced, or altered seals and/or serial numbers.
• Damage caused by abuse, misuse, accident, water, or theft.

Except as stated, iTouchless makes no express or implied warranties, including warranties of merchantability or fitness for a particular purpose. iTouchless is not liable for consequential or incidental damages. Liability is limited to product replacement. iTouchless disclaims all warranties not covered by this limited warranty. Any implied warranties are limited to the terms of this warranty. Accessory Parts, including the Charger and Battery, are not covered.

If the Cleaner fails during the warranty period, contact www.iTouchless.com/contacts/ to request a Repair # before returning. Packages without a Repair # will not be accepted. Return packages FREIGHT PREPAID via an insured carrier (e.g., UPS, FedEx) and include a check for return postage along with the authorized Repair #. Refer to the warranty email from iTouchless for details. Warranty fees (including return postage) vary by location: Contiguous 48 U.S. States ($9.95+), Alaska/Hawaii ($49.95+), Canada ($29.95+). iTouchless does not cover warranty service postage fees.

Return Address:
iTouchless Housewares & Products, Inc.
23497 Eichler Street, Unit A, Hayward, CA 94545, USA
Attn: Product Return Repair #___________________

We will repair or ship a working Cleaner within 30 working days after receipt, subject to these conditions. This warranty grants specific legal rights, and you may have other rights varying by state or province. For more information, visit www.iTouchless.com.