MINIS FORUM Mini PC Installation Guide and FCC Statement
This document provides installation and setup instructions for the MINIS FORUM Mini PC, along with important FCC compliance information.
4 Installation Operation
This section details the physical installation and component upgrades for your Mini PC.
Step 1: Removing the Bottom Case
Diagram shows removing four screws from the bottom case and then removing the case. A warning indicates to remove cables.
IMPORTANT: Remove the cables!
DIY Component Installation
2. DIY DDR Installation
Diagram shows a slot for DDR5 memory. Instructions describe inserting the memory into the slot according to the diagram.
3. DIY SSD Installation
Diagram shows an M.2 2280 SSD and its slot. Instructions describe installing the SSD card into its slot by inserting it slantwise and fixing it with screws.
6. DIY OCulink Adapter Card Installation
Diagram shows the OCulink port and the adapter card. Instructions describe removing the dust cover of the OCulink port, installing the OCulink adapter card into the M.2 slot, and fixing it with a screw.
7. Final Assembly and Connections
Diagram shows connecting cables to connectors, closing two covers, and tightening screws on the covers to secure them in place.
Instructions describe inserting the cable into the connectors, closing the two covers, and tightening all the screws on the two covers to secure them in place.
Mounting the Mini PC
Installing on a Universal Screen Mount
Diagrams illustrate mounting the Mini PC to a universal screen mount. The process involves placing the Mini PC upside down on a flat surface, mounting the bracket to the Mini PC's bottom screw holes using included screws (A), and then securing the installed Mini PC to the back of the mounting device using screws (B).
Warning! Do not over tighten the screws as it may damage your Mini PC.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: it must not cause harmful interference, and it must accept any interference received.
This equipment has been tested and found to comply with the limits for a Class B digital device, designed to provide reasonable protection against harmful interference in a residential installation. It generates, uses, and can radiate radio frequency energy, and may cause interference if not installed and used according to instructions.
If interference occurs, users are encouraged to try correcting it by reorienting/relocating the antenna, increasing separation between equipment and receiver, connecting to a different circuit, or consulting a dealer/technician.
FCC regulations restrict operation to indoor use only. Operation is prohibited on oil platforms, cars, trains, boats, and aircraft (except large aircraft flying above 10,000 feet). Transmitters in the 5.925-7.125 GHz band are prohibited from controlling unmanned aircraft systems.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits for an uncontrolled environment. To avoid exceeding these limits, maintain a distance of at least 20cm (8 inches) from the antenna during normal operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Contact Information
Manufacturer
Manufacturer: Micro Computer (HK) Tech Limited
Website: https://www.miniscloud.com
Address: FLAT/RM 18, 28/F, Shui On Centre, 6-8 Harbour Road, Waterfront Wan Chai, Hong Kong
TEL: 852-23860910
Online Technical Support
Website: https://www.minisforum.com/new/support
Email: support@minisforum.com