Shark IX140 Series Pet Cordless Stick Vacuum User Manual

Quick Start Guide

[ Please make sure to read the enclosed Shark® Owner's Guide prior to using your vacuum.]

Use this Quick Start Guide to start using your new vacuum's great features.

For questions, visit us online at sharkclean.com/support

Register your vacuum at registeryourshark.com

WHAT'S INSIDE:

• A. Handheld Vacuum
• B. Motorized Floor Nozzle
• C. Wand
• D. Dusting Brush
• E. 8" Crevice Tool
• F. Li-Ion Charger
• G. Post Motor Filter (Pre-Installed)

ASSEMBLY

Diagram illustrating the assembly process. Component B (Motorized Floor Nozzle) connects to Component C (Wand) with an audible click (1). Component A (Handheld Vacuum) connects to Component C (Wand) with an audible click (2).

For complete maintenance instructions, see the enclosed Owner's Guide.

For additional parts and accessories, visit sharkaccessories.com.

For additional batteries and charging accessories, visit sharkclean.com/batteries.

POWER SETTINGS

OFF:

Slide switch to the top to turn off power.

Standard Mode / Bare Floor Setting:

To begin vacuuming in Standard Mode, slide switch to the appropriate setting. The brushroll spins slowly to clean bare floors and low-pile area rugs.

Carpet Setting:

The brushroll spins faster to pick up debris below the surface of your carpets.

BOOST MODE:

For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.

NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the trigger to go into Boost mode.

NOTE: Select Carpet setting for stuck-on dirt and debris.

LI-ION BATTERY

In Use Battery Indicator Lights:

• Full Charge:
• Mid Charge:
• Low Charge:
• Nearly Empty:
• No Charge:

Charging Battery Indicator Lights:

• Low Charge:
• Mid Charge:
• Nearly Full:
• Full Charge:

NOTE: The battery comes partially charged. Charge fully before first use.

CHARGING

To charge, remove the handheld vacuum from the wand by pressing the Wand Release button and pulling up. Plug the charger into the charging port.

Battery Run Time

VERSATILE CLEANING

Slide the power button to the desired setting. Step on the floor nozzle and tilt the handheld vacuum back.

NOTE: Brushroll will only engage when the handle is tilted back.

To detach the wand for above-floor cleaning, stand the vacuum upright, then press the Nozzle Release button on the bottom of the wand and pull the wand up to disconnect it.

Diagram showing how to detach the handheld vacuum from the wand by pressing the Wand Release button and lifting the handheld vacuum off the wand.

Attach a cleaning accessory, then choose the power setting.

EMPTYING THE DUST CUP

1. To empty the dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum.
2. Position the dust cup over a trash bin and slide the CleanTouch™ Dirt Ejector Button forward.

©2019 SharkNinja Operating LLC. SHARK and ROCKET are registered trademarks of SharkNinja. CLEANTOUCH is a trademark of SharkNinja Operating LLC. CleanTouch

Model Number: IX140_QSG_PP_Mv8

DOWNLOAD

Shark IX140 Series Pet Cordless Stick Vacuum:

• Quick Start Guide - [Download PDF]
• Owner's Guide - [Download PDF]