Unitech MS340 Quick Start Guide

Step 1: Getting Started (For USB Cable)

Installing the scanner to the Host System

1. Connect the USB cable of the MS340 to the USB port on your host PC.
2. After six beeps, the MS340 is successfully connected with your host PC, and the driver will start to install automatically.
3. Proceed to Step 2: Test & Finish.

Step 2: Test & Finish

Scan the following barcode. If the word "unitech" appears on your screen, the scanner has been successfully installed.

Set All Defaults

(Scan the 'Set All Defaults' barcode to reset to factory defaults)

Tips for Switching Cable

Before removing the cable from the scanner, it is recommended that the power on the host system is off and the power supply has been disconnected from the unit.

1. Find the small "Pin-hole" on the bottom of the unit.
2. Use a bended regular paperclip and insert the tip into the hole.
3. You will hear a "click", then gently pull on the strain-relief of the cable, and it will slide out of the scanner.

(Illustration showing a paperclip being used to release the cable)

Configuration Flow Chart

Scan the following barcodes for configuration:

• Start Configuration: Scan the "Start of Configuration" barcode.
• Scan necessary labels for parameters: Scan all necessary labels for parameters that meet your applications.
• Interface Selection: Choose your interface (USB, RS232, Keyboard, Virtual COM).
• Reading Mode Selection: Select your desired reading modes (e.g., Trigger ON/OFF, Presentation, Flash, Good Read OFF, Continuous/Auto Power ON).
• End Configuration: Scan the "End of Configuration" barcode to end the programming.
• Save Parameters: Scan the "Save Parameters" barcode to permanently save your programmed settings.

Interface Selection

Choose your preferred interface:

• USB*
• Keyboard
• RS232
• Virtual COM

* Default Option

Reading Mode Selection

Select your desired reading modes:

• Trigger ON / OFF*
• Presentation
• Flash
• Good Read OFF
• Flash / Auto Power On
• Testing
• Continuous / Auto Power ON
• Continuous/Trigger OFF

Select Terminator

Choose your terminator settings:

• CR*
• Space
• STX-ETX
• CR+LF
• HT (TAB)
• LF
• None

RS232 Mode Parameters: Set Up BAUD Rate

Select the desired BAUD rate for RS232 mode:

• 9600*
• 19200
• 1200
• 38400
• 2400
• 4800

Language Selection

Select the language for your scanner's interface and output:

• US English*
• UK English
• Italian
• Spanish
• French
• German
• Swedish
• Switzerland
• Hungarian
• Japanese
• Belgium
• Portuguese
• Denmark
• Netherlands
• Turkey