Unitech MS836B 2.4G Wireless Laser Barcode Scanner
Quick Start Guide
unitech because we care
Charging
Plug the USB cable into the port on the scanner and into a USB port on the host computer.
Connect Dongle To Host
Plug the USB Dongle into a free USB port of a host computer. The MS836B is now ready to use.
Test & Finish
Open a word processing program such as Microsoft Word or Notepad and scan the following barcode:
If the word "Unitech" appears on the screen, you have successfully installed your scanner.
Buzzer Description
- One long beep: Switch on
- One low beep and two high beeps: setup code or data saved.
- One short beep: pairing up with the receiver successfully.
- One short low beep and one short high beep: Good Read and data send.
- Three continuous short beeps: Alarm prompt
LED Description
Red Light
- Charging: Light on
- Charging finished: Light off
Green Light
- Slow flash: Bluetooth SPP/BLE pairing
- Light On: Scanner is connected to the receiver, USB or Bluetooth successfully.
- Quick Flash: Entering the pairing mode
- Flash once: Data upload successfully.
Default Setting
Factory default. Note: With (*) is the factory default.
Pairing Function
Bluetooth HID pairing. Note: The scanner can be searched by other Bluetooth devices after scanning Bluetooth HID pairing code.
Wireless Bluetooth Setting
2.4G
Bluetooth HID
Bluetooth SPP
iOS show / hide the Keyboard
Show or hide. Note: Only support under Bluetooth mode.
Battery Display
Display battery capacity. Note: Battery Percentage display.
USB Interface Type
*USB-HID
USB-COM
Operation Mode
*Auto Mode
Batch Mode
Wedge Mode
Clear all data
Upload all data
Display stored data
Beeper Control
Off
High
Medium
Low
Note: The Off Code only turns off the short high beep of data send; the setting sound still exists.
Good Read Indicator
*Default beeps
One beep
Auto Power Off After Idle
Immediate sleep
10 s
30 s
1 min
2 min
5 min
10 min
30 min
Language Settings
- USA
- Germany
- France
- Italy
- Canada
- Spain
- Brazil
- Sweden
- Portugal
- Belgium
- Turkey-F
- Turkey-Q
- Japan
- Universal language
Terminator
*None
CR
LF
TAB
CR/LF
Display Version
Software version
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
