Shark Rotator Professional Lift-Away Quick Start Guide

What's Inside

• A: Handle
• B: Hose
• C: Wand
• D: Vacuum Pod
• E: Motorized Floor Nozzle
• F: 12" Crevice Tool
• G: Dusting Brush

Assembly

Follow these steps to assemble your vacuum:

1. Connect the Vacuum Pod (D) to the Motorized Floor Nozzle (E) at the base. A click indicates a secure connection.
2. Attach the Wand (C) to the top of the Vacuum Pod (D). A click indicates a secure connection.
3. Connect the Handle (A) to the top of the Wand (C). A click indicates a secure connection.
4. Connect the Hose (B) from the Handle (A) to the port on the Vacuum Pod (D). A click indicates a secure connection.

Attach Onboard Accessories

Accessories can be attached to the handle or wand.

1. Attach accessories like the 12" Crevice Tool (F) or Dusting Brush (G) to the Handle (A). A click indicates a secure connection.
2. Attach accessories like the 12" Crevice Tool (F) or Dusting Brush (G) to the Wand (C). A click indicates a secure connection.

Maintenance

Empty the dust cup after each use.

To empty the dust cup: Press the release button and lift the cup. Empty contents. Replace the cup.

To clean the filters:

1. Remove the filters.
2. Rinse the foam and felt filters with water only.
3. Allow filters to air-dry completely before reinstalling.
4. Tap loose dirt from filters as needed between washes.

TIP: Wash foam and felt filters every 3 months. Rinse with water only and allow to air-dry completely before reinstalling. Tap loose dirt from filters as needed between washes.

Note: The foam filter may discolor over time. This is normal.

2 Ways to Clean

Upright Mode

Power: For cleaning bare floors or with accessories.

Suction Control: Slide the control to MIN for more maneuverability on carpets. Slide to MAX for more suction on bare floors.

Brushroll: For carpet cleaning with brushroll. To activate the brushroll, step on the floor nozzle and tilt the handle back.

Lift-Away Mode

To engage Lift-Away mode: Release the pod by pressing the Lift-Away Release button. The pod can then be carried or placed nearby.

Handle Release: Press the Handle Release button to detach the handle from the wand.

Wand Release: Press the Wand Release button to detach the wand from the vacuum pod.

Accessories can be attached to the handle or wand in Lift-Away mode.

Additional Information

For additional parts and accessories, visit sharkaccessories.com.

For questions or to register your product, visit us online at sharkclean.com.

©2018 SharkNinja Operating LLC.