ECOVACS DEEBOT IN20 PRO / IN20

Important Safety Instructions

When using an electrical appliance, basic precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. SAVE THESE INSTRUCTIONS.

1. This appliance can be used by children aged 8 years and above, and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
2. Clear the area to be cleaned. Remove power cords and small objects on the floor that could become entangled in the appliance. Tuck in carpet fringes and lift curtains and tablecloths so they do not trail on the floor.
3. If the floor has a slope in the area to be cleaned (e.g., a step or stairs), ensure the appliance can detect the step without falling. A physical barrier may need to be placed at the edge of the slope to prevent the appliance from falling. Ensure the physical barrier does not pose a tripping hazard.
4. Use the appliance only as described in this manual. Use only accessories recommended or sold by the manufacturer.
5. Ensure the power supply voltage corresponds to that indicated on the charging dock.
6. For INDOOR household use ONLY. Do not use the appliance outdoors or in industrial or commercial environments.
7. Use only the rechargeable battery and the original charging dock supplied with the appliance by the manufacturer. Non-rechargeable batteries are prohibited.
8. Do not operate the appliance without the dustbin and/or filter installed.
9. Do not operate the appliance in the presence of lit candles or fragile objects.
10. Do not use the appliance in extremely hot or cold environments (temperature below -5°C/23°F or above 40°C/104°F).
11. Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
12. Do not operate the appliance in a room where an infant or child is sleeping.
13. Do not use the appliance on wet surfaces or surfaces covered with water.
14. Do not allow the appliance to pick up large objects such as stones, large pieces of paper, or any object that could obstruct it.
15. Do not use the appliance to pick up flammable or combustible materials (such as gasoline and printer or copier toner) or in areas where these products may be present.
16. Do not use the appliance to pick up objects that are burning or smoking (such as cigarettes, matches, hot ashes) or anything that could cause a fire.
17. Do not place any object into the suction port. Do not use the appliance if the suction port is blocked. Remove dust, lint, hair, or anything that may reduce airflow from the suction port.
18. Take care not to damage the power cord. Do not move the appliance or charging dock by pulling the power cord, do not use the power cord as a handle, do not close a door on the power cord, and do not pull the power cord around sharp edges or corners. Do not run the appliance over the power cord. Keep the power cord away from hot surfaces.
19. If the power cord is damaged, it must be replaced by the manufacturer or its service agent to avoid a hazard.
20. Do not use the charging dock if it is damaged. If the power supply is damaged or defective, stop using it and do not attempt to repair it.
21. Do not use the appliance if the power cord or dustbin is damaged. Do not use the appliance or charging dock if they are not functioning correctly, have been dropped, damaged, left outdoors, or come into contact with water. They must be repaired by the manufacturer or its service agent to avoid a hazard.
22. Turn off the power before cleaning or performing maintenance on the appliance.
23. The plug must be removed from the socket-outlet before cleaning or maintenance of the charging dock.
24. For disposal of the appliance, remove the appliance from the charging dock, turn off the power, and remove the battery.
25. The battery must be removed from the appliance before it is scrapped and disposed of in accordance with local laws and regulations.
26. Dispose of used batteries in accordance with local laws and regulations.
27. Do not incinerate the appliance, even if it is severely damaged. Batteries may explode when exposed to fire.
28. If the charging dock is not used for a long period, unplug it.
29. The appliance must be used in accordance with the instructions in this instruction manual. ECOVACS ROBOTICS cannot be held responsible for any damage or injury caused by incorrect use.
30. The robot contains batteries that only qualified persons can replace. To replace the robot's battery, contact customer service.
31. If the robot is not used for a long period, turn it off for storage. Unplug the charging dock.
32. WARNING: To recharge the battery, use the detachable power supply unit CH2405 supplied with the appliance.

Device Update

Generally, some devices are updated every two months, but this is not always precise. Some devices, especially those sold more than three years ago, will only be updated if a critical vulnerability is discovered and corrected.

To satisfy FCC RF exposure and integrated circuit safety requirements, a distance of at least 20 cm must be maintained between this appliance and individuals when the appliance is in operation. To ensure compliance with these requirements, it is not recommended to operate the appliance at a distance less than that indicated. The antenna used for this transmitter must not be co-located with any other antenna or transmitter.

Ensure the robot is always connected to a network for intelligent functions to work correctly.

Electrical Safety Symbols

Correct Disposal of This Product

This marking on the product or its packaging indicates that this product must not be disposed of with other household waste throughout the European Union. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, use the return and collection systems or contact the retailer where the product was purchased. They can recycle this product safely.

For European Union Countries: For information on the EU Declaration of Conformity, visit https://www.ecovacs.com/global/compliance.

Declaration of Conformity of the European Union

Information on the disposal of Waste Electrical and Electronic Equipment (WEEE): This symbol on the product or its packaging indicates that used electrical and electronic products should not be mixed with unsorted municipal waste. For proper treatment, return your used equipment to designated collection points. Correct disposal of this product will help save valuable resources and prevent potential negative effects on human health and the environment, which could result from inappropriate waste treatment. For returning your used device, use the return and collection systems or contact the retailer where the product was purchased. Please contact your local authority for details on the nearest designated collection point. Penalties may apply for incorrect disposal of such waste, in accordance with national legislation.

RoHS Directive (Restriction of Hazardous Substances)

Ecovacs Home Service Robotics Co., Ltd. and Ecovacs Robotics Co., Ltd. hereby declare that the entire product, including parts (cables, cords, etc.), complies with the requirements of Directive 2011/65/EU and Commission Delegated Directive (EU) 2015/863 on the restriction of certain hazardous substances in electrical and electronic equipment ("RoHS Recast" or "RoHS 2.0").

Radio Equipment Directive

Ecovacs Robotics Co., Ltd. hereby declares that the product listed in this section conforms to the essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU.

Authorised Representative in Europe:

ECOVACS Europe GmbH
Holzstrasse 2 | D-40221 Düsseldorf | Germany

Ecovacs Robotics Co., Ltd. declares that the product complies with the essential requirements and other relevant provisions of Directive RoHS 2011/65/EU and Commission Delegated Directive (EU) 2015/863, and the Radio Equipment Directive 2014/53/EU.

The Declaration of Conformity can be consulted at: https://www.ecovacs.com/global/compliance.

PACKAGE CONTENTS

Robot

Side Brush

Charging Dock

Instruction Manual

Tampons

OZMO Pro 2.0 Vibrating Mopping System and Suction Module (DKX55)

• OZMO Pro 2.0 Vibrating Mopping System
• Washable Mopping Pad
• Suction Module (pre-installed)

Water Tank and Mopping Pad Module (DKX56)

• Water Tank (pre-installed)
• Mopping Pad Plate
• Washable Mopping Pad

Note: Figures and illustrations are for reference only and may not represent the appearance of the product. Product design and specifications are subject to change without notice.

PRODUCT DIAGRAM

Robot

Top View:

• Navigation Module
• Infrared Module
• Top Cover
• Buttons
• Bumper

Buttons:

• Short Press: Return to Charging Dock
• Short Press: Start/Pause/Resume
• Long Press: Power Off
• Long Press: Start/End Spot Cleaning
• Long Press: Child Lock

Reset Button

• Connect with App: Briefly press the Reset button (RESET) and follow voice prompts to connect to the app.
• Reset to Default Settings: Press and hold the Reset button for 5 seconds. After hearing the voice prompt, the startup music will play, and the robot's default settings will be restored.

Charging Contacts

Wi-Fi Status Indicator

Edge Sensor

Bottom View (DKX55):

• Anti-drop Sensor
• Carpet Detection Sensor
• Brush
• Suction Module
• Universal Wheel
• Side Brush
• Brush Release Button
• Drive Wheels

OZMO Pro 2.0 Vibrating Mopping System:

• Tank
• Water Inlet
• Washable Mopping Pad
• Tank Release Button

Dustbin:

• Dust Exhaust Port
• Dustbin Handle
• Filter
• Sponge Filter
• Filter Net
• Release Button

Data Transfer Port: Reserved for professional maintenance personnel.

Robot (DKX56)

Bottom View (DKX56):

• Anti-drop Sensor
• Carpet Detection Sensor
• Brush
• Fixing Slots for Mopping Pad Plate
• Tank
• Universal Wheel
• Side Brush
• Brush Release Button
• Drive Wheels

Mopping Pad Module:

• Mopping Pad Plate
• Washable Mopping Pad

Charging Dock

• Charging Contacts
• Pad Placement Orifices
• Cable Routing Channel
• Power Plug

Note: Figures and illustrations are for reference only and may not represent the appearance of the product. Product design and specifications are subject to change without notice.

SENSORS

REMARKS BEFORE CLEANING

[Diagram: Tidying up furniture like chairs]

Tidy the area to be cleaned by placing furniture, such as chairs, in their exact positions.

[Diagram: Opening doors]

For the first use, ensure all room doors are open so the DEEBOT can fully explore your home.

[Diagram: Placing a barrier at a slope]

It may be necessary to place a physical barrier at the edge of a slope to prevent the appliance from falling.

[Diagram: Tidying cables, clothes, shoes]

Tidy up objects such as cables, clothing, and shoes for optimal cleaning efficiency.

[Diagram: Folding carpet fringes]

Before using the appliance on a low-pile carpet with fringes, fold the edges under.

[Diagram: Person standing in narrow space, not blocking sensors]

It is important that no one stands in narrow spaces, such as corridors, and ensure sensors are not blocked.

QUICK START

Remove all protective materials before use.

1. Installation

[Diagram: Robot being placed, indicating a 'click' sound]

The click indicates that the installation is correct.

2. Position the Charging Dock

Keep the area around the charging dock free of objects, especially those with reflective surfaces.

Note: It is recommended to place the charging dock on the floor to test all robot functions.

[Diagram: Charging dock placement with clearance requirements: >0.5m (1.64') on sides, >1.5m (4.92') in front]

3. Install Pads (for homes with baseboards)

[Diagram: Attaching pads to the mopping plate]

Remove the protective sticker and insert the adhesive end into the installation orifices.

DOWNLOAD THE ECOVACS HOME APP

To enjoy all available features, it is recommended to control your DEEBOT via the ECOVACS HOME app.

1. Scan the QR code under the top cover to download the app.

[Diagram: Robot with arrow pointing to QR code location under top cover]

2. Search for ECOVACS HOME to download the app.

[App Store icon] [Google Play icon] ECOVACS HOME

CONNECT DEEBOT TO THE APP

Wi-Fi Network Requirements:

• You are using a 2.4 GHz or 2.4/5 GHz mixed network.
• Your router supports 802.11b/g/n and IPv4 protocols.
• You are not using a VPN (Virtual Private Network) or proxy server.
• You are not using a hidden network.
• WPA and WPA2 encryption using TKIP, PSK, AES/CCMP.
• WEP EAP (Enterprise Authentication Protocol) is not supported.
• You are using Wi-Fi channels 1-11 if you are in North America and 1-13 outside North America (refer to local regulatory body).
• If you are using a network extender/repeater, the network name (SSID) and password are the same as your main network.
• Enable WPA2 on your router.

Wi-Fi Indicator

Please note that to enjoy intelligent functions such as remote start, voice interaction, 2D/3D map display, and control settings, as well as personalized cleaning (depending on the product), users must download and use the ECOVACS HOME app, which is constantly updated. You must accept our Privacy Policy and User Agreement before we can process certain basic and necessary information from you and allow you to use the product. If you do not accept our Privacy Policy and User Agreement, some of the aforementioned intelligent functions cannot be used via the ECOVACS HOME app, but you can still enjoy the basic functions of this product in manual mode.

POWER ON DEEBOT

Press and hold the power button for 3 seconds to power on the DEEBOT.

[Icon: Power button with '3s' indicator]

CHARGE DEEBOT

Briefly press the button to recall the DEEBOT and return to the dock for charging.

[Diagram: Robot returning to charging dock]

Charging Time: Approximately 6.5 hours.

USE DEEBOT

Remove the mopping pad/plate before proceeding with mapping. When creating a map for the first time, follow the DEEBOT's instructions to resolve minor issues.

For example, the DEEBOT may get stuck under furniture. Refer to the following instructions:

• If possible, raise low-profile furniture.
• Cover the underside of furniture.
• Configure virtual boundaries via the app.

Before the first vacuuming, ensure the DEEBOT is at the charging dock and fully charged. Briefly press the button to start cleaning and mapping.

[Icon: Power button]

Note:

• Do not frequently remove the washable mopping pads.
• Do not use a cloth or other object to scrub the mopping pad plates.
• When the ECOVACS HOME app indicates the pads need replacing, please replace them in time. Discover more accessories in the ECOVACS HOME app or on the website https://www.ecovacs.com/global.

TECHNICAL SPECIFICATIONS

The Wi-Fi module output power is less than 100 mW.

Note: These technical specifications may be modified for continuous improvement. Discover more accessories at https://www.ecovacs.com/global.

[Diagram: Robot with QR code overlay]

Please use your mobile camera to scan the QR code and get the user guide.