Tools Required
- Metal Spudger (1)
- Phillips #00 Screwdriver (1)
Step 1 — Remote Buttons
[Image Description: Hands holding the Logitech Harmony Smart Control Remote. One hand is sliding a grooved cover off the end of the remote using both thumbs.]
With both thumbs, slide the grooved cover off the end of the remote.
[Image Description: Hands holding the remote, showing the battery compartment. The battery is being removed.]
Remove the battery once the cover is removed.
Step 2
[Image Description: Close-up of the underside of the Logitech Harmony Smart Control Remote. Two 4mm Phillips screws are visible and circled. A Phillips #00 screwdriver is shown removing one of the screws.]
With the PH00 bit, remove both of the 4mm Phillips screws on the remote.
[Image Description: Close-up of the underside of the remote after screws have been removed, showing the casing starting to separate.]
Step 3
[Image Description: A hand is using a metal spudger to carefully pry open the casing of the Logitech Harmony Smart Control Remote.]
Using a metal spudger, pry the remote. Maneuver around to separate both sides.
[Image Description: Hands are shown separating the two plastic halves of the Logitech Harmony Smart Control Remote casing.]
Step 4
[Image Description: A hand is using a metal tool (likely the spudger) to carefully pry up the circuit board from the plastic housing of the remote.]
Manually separate the two pieces of plastic.
Using the metal piece from the housing, pry up the circuit board. Do not disconnect anything.
[Image Description: The circuit board is shown partially lifted out of the plastic housing.]
When the circuit board is pried, slide the circuit board out of the housing.
Step 5
[Image Description: Hands holding the disassembled Logitech Harmony Smart Control Remote, pointing to the button area. The user is shown removing buttons from the remote.]
From the front of the remote, remove the buttons. Clean or replace the necessary buttons.
Reassembly
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-09-08 04:28:47 AM.
