Aerpro G184V User Manual

Product Features

• Image Sensor: 1/3" CMOS
• TV Lines: 600
• Resolution: 756 x 504
• Minimum Illumination: 0.1 Lux
• TV System: NTSC
• Waterproof Rating: IP68
• Viewing Angle: 160 Degrees
• Video Output: 1.0Vp-p 75ohm
• Parking Guidelines: Yes (Removable)
• Operating Voltage: 12V DC (Negative Ground)
• Operating Temperature: -20 Degrees C to +70 Degrees C

Disclaimer

Prior to Installation

Read the manual prior to installation. Technical knowledge is necessary for installation. Please ensure you use the correct tools to avoid damage to the vehicle or product. Aerpro cannot be held responsible for the installation of this product.

Technical Support

Aerpro aims to provide a fast and suitable resolution for any technical issues. When contacting Aerpro, please provide as much information as possible to expedite the process. Use the dedicated online technical support centre: aerpro.com/contact.

Contents

• Camera with Male 4-pin camera connector
• 10m Female 4-pin to Male 4-pin extension cable
• Female 4-pin camera connector to 1x Yellow Female RCA and 1x Female DC power connector
• 1.5m DC power cable with Male DC connector to bare wires
• Male to Male RCA adapter
• Instructions

Installation Guide

1. Remove the third brake light from the vehicle and unplug the connection cable.
2. Refit the G184V to the vehicle, taking care not to trap any cables.
3. Connect the 4-pin of the extension cable to the camera and thread through the vehicle.
4. Connect the other 4-pin connector on the extension to the 4-pin connector found on the RCA/DC split wire.
5. Use the DC power cable to plug into the black connector and proceed to wire the red wire to a 12V source and the black wire to a ground source.
6. Use the Male to Male RCA adapter to plug into the yellow RCA on the harness, and then plug this into the aftermarket accessory's video input.
7. Test the camera connection by turning on the ignition. The rear camera feed should now be visible on screen. Put the vehicle into reverse and the reverse camera feed will automatically populate on screen. If the camera feed is unresponsive, please uninstall the wiring and reinstall carefully in accordance with the above steps.
8. The camera will be default with parking guidelines. To remove this, simply cut the green wire found on the camera's connector.

For further help and support, please contact Aerpro directly at aerpro.com/contact and fill out a support ticket with the full details of your issue.