Aerpro APVAU12 Audi Camera Add On Interface

Product Overview

The APVAU12 by Aerpro is an interface designed to allow the addition of a front or rear aftermarket reverse camera to the original vehicle's screen. This product is compatible with a range of non-MMI Audi vehicles equipped with Concert/Symphony head units and 6.5" centre displays.

Key Components Included:

• Interface Module
• Interface Harness (x3)
• Instruction Manual

Product Image Description: The interface module is a black box labeled 'Connects2 ...connecting to the aftermarket'. It is shown with several wiring harnesses, including a main harness with multiple connectors, a camera harness with two yellow RCA connectors (one labeled GND, one RIGHT TURN OUT), and an LVDS harness.

Application

This interface is suitable for the following Audi models:

• Audi A4 (2008-2015)
• Audi A5 (2007-2015)
• Audi Q5 (2008-2015)

Specifically for vehicles with non-MMI Concert/Symphony head units and 6.5" centre displays.

Fitting Guide

Prior to Installation:

Read this manual thoroughly before commencing installation. Technical knowledge is required. Ensure the installation area is free of moisture and heat sources. Use appropriate tools to prevent damage to the vehicle or product. Aerpro is not responsible for installation errors.

Installation Steps:

Step 1: Head Unit Removal

Begin by carefully removing the dashboard panelling above and below the main Concert/Symphony head unit. Undo any surrounding screws and then remove the head unit from the dashboard.

Step 2: LVDS Connector Connection

Locate the rear of the upper dash display. Disconnect the original equipment manufacturer (OEM) LVDS connector. Connect this OEM LVDS connector to the female connector on the supplied LVDS harness. Subsequently, connect the male connector from the LVDS harness to the back of the upper dash display.

Diagram Description: An image shows the rear of an Audi Concert head unit. Text indicates "LVDS replaced./connect our device in car Circuit" and highlights "Camera inputs".

Step 3: Power/CAN-Bus Harness Connection

Access the climate control panel. Disconnect the specified connection (refer to image). Connect the female connector from the vehicle power/CAN-Bus harness to the vehicle's existing connector. Then, connect the male connector of this harness directly to the back of the climate control panel.

Diagram Description: An image shows a connector on the climate control panel, with a red circle highlighting the connection point.

Step 4: Dipswitch Configuration

Configure the dipswitches on the interface module according to the desired setup. The following table details the functions attributed to each dipswitch:

Step 5: Camera Harness Connections

Connect the white connector from the camera harness to the interface module. Then, make the following connections to the vehicle:

Note: The White wire connection is only required for manual vehicles.

Step 6: Final Connections and Testing

Once all camera connections are made, reconnect the head unit's main power connection. Test the camera functionality thoroughly before reassembling the dashboard. If the system is unresponsive, uninstall the interface and wiring, then reinstall carefully following the steps outlined above.

Technical Support

Aerpro aims to provide prompt and effective resolutions for any technical issues encountered. When contacting Aerpro support, please provide as much detailed information as possible to expedite the process.

For assistance, please use the dedicated online technical support centre:

aerpro.com/contact