Product Overview
The APVTY16 harness is designed for use with Aerpro APVTY14C or APVTY12C reverse camera kits. It provides a reverse gear trigger for early model Toyota OE units that lack this functionality in their original 28-pin connector.
Installation Instructions
Step 1: Disconnect Original Harness
Disconnect the original 28-pin connector harness from the vehicle's head unit.
[Diagram showing the rear of a car stereo unit with multiple connectors, highlighting the 28-pin connector.]
Step 2: Connect APVTY16 Harness
Replace the existing 28-pin connector with the APVTY16 connector.
Step 3: Reconnect Original Connector
Reconnect the original 26-pin connector to the APVTY16 patch wire connector.
Step 4: Extend and Connect Reverse Trigger Wire
Extend the loose wire labeled "Violet/White Trace" to the factory interior fuse box. Securely connect this wire to the factory's red wire with a white trace, which serves as the reverse output wire.
[Diagram illustrating the vehicle's interior fuse box, showing various fuse slots and relays. It indicates the specific location for the Vehicle Reverse Gear Signal, identified by a wire colored red with a white trace.]
Technical Assistance
For assistance with setup or usage of your Aerpro product, please contact Aerpro Support.
Aerpro Support
Australia
TEL: 03 - 8587 8898
FAX: 03 - 8587 8866
Hours: Mon-Fri 9am - 5pm AEST
Please retain this user guide for future reference.
Product Information
Visit AERPRO.COM for more details.
